MicroVantage MAS Series - Beverage Grade0 pages
MicroVantage™ MAS-B Series
Beverage Grade Polyethersulfone Membrane Filter Cartridges
•t Absolute retention ratings from 0.1 to1.2 microns
•t 7.2 square feet (0.67 m2) of media surface area per ten inch
length for optimal performance
•t Fully integrity tested to ensure reliable performance in critical
applications
•t 100% flushed with 18 megohm DI water for low extractables
•t Rigid, molded cage protects pleated media and strengthens
structural stability
•t Manufactured in a Class 10,000 Clean Room environment for
high purity
•t Complies with Food & Drug Administration’s CFR criteria for
food & beverage contact
•t Meets USP Class VI Biological Test for plastics
•t Available in standard lengths and end cap configurations to
fit most filter housings
•t Produced up to 40 inches in length (10 inch modules)
Applications
Food & Beveragettt
Malt Beveragesttt
Beertttt
RO Pre/Post Filtration tt
Wine
Bottled Water
Process Water
Water & Wastewater
Specifications & Operating Parameters
Pore Sizes 0.1, 0.2, 0.45, 0.65, 0.8, 1.0, 1.2 microns absolute retention Maximum Operating Temperature 176°F ( 80°C)
Nominal Lengths 9.75” (24.7 cm), 10”
(25.4 cm), 20” (50.8 cm), 30” (76.2 cm), 40” (101.6 cm)
Recommended Change-out Differential Pressure
Outside Diameter 2.67” (6.78 cm)
Maximum Differential (Collapse) Pressure
35 psid (2.4 bar)
75 psid @ 70°F (5.2 bar @21°C), 40 psid @176°F (2.8 bar @ 80°C)
Inside Diameter 1.0” (2.54 cm)
Sanitization and Sterilization
Media Surface Area 7.2 sq.ft. (0.67 m2)
Hot water at 175°F (80°C) at 5 psid for 30 minutes
In-line steam at 257°F (125°C) @ 1 psid (0.7 bar) for 30 minutes
Autoclavable at 257°F (125°C) for 30 minutes
per 10 inches filter length
Gaskets/O-rings
Silicone, Buna N, EPR, Viton, Teflon Encapsulated Viton (O-rings only)
Materials of Construction
Filter Media: tt
Outer Cage tt
Inner Core: tt
End caps: tt
Polyethersulfone
Polypropylene
Polypropylene
Polypropylene
FDA and USP Compliance
All filters are manufactured of virgin polypropylene materials
with no additives or other manufacturing agents. All
polypropylene materials comply with the requirements of Food
and Drug Administration Title 21 of The Code of Federal
Regulations 174.5, 177.1520 and 177.1630. All components meet
current USP Class VI biological tests for plastics
www.shelco.com