A5S0DD0 (non hazardous area)0 pages
A5S0
Differential-Hall-Effect based Sensors
for Detection of Speed in Non Hazardous Areas
Series A5S0DD0 / A5S0DS0
KEY FEATURES
t Detection of rotational speed
t in non hazardous areas
t Speed range from 0 Hz up to 25 kHz
t (response time < 20 microseconds)
t Air gap to the target / pole wheel up to
t 2.5 mm (depending on the profile size)
t Temperature range –40…+125 °C
t (–40…+255 °F)
t Differential principle diminishes the
t influence of external magnetic stray t
t fields and of machine vibration
t Sealed stainless steel enclosure
t > 200 bar pressure to sensor tip
t Available for connection via tight plug,
t or with firmly attached cable (PVC
t or Teflon® insulated)
t Powerful square wave output signal
t equally high over the entire speed
trange
A5S0 Overall View
A5S0 sensors – the best choice for demanding applications
t Sensor short circuit proof and
t protected versus polarity error
t Accepting fine and coarse profiles,
t as gear wheels, slots, cams, holes in
t any ferrous material
The correct choice of sensor is always a prerequisite to attaining a successful solution.
BENEFITS
Our A5S0 sensors are based on the proven Differential-Hall-Effect principle. Their low
t Contact-free with a large air gap, so
t the potential for damage is eliminated
end of 0 Hz allows to monitor the machine down to zero speed. They are contact-free,
wear-free, maintenance-free and unsusceptible versus external magnetic stray fields
and machine vibration. These characteristics make the series of A5S0 sensors especially
suited for all applications where high levels of accuracy and reliability are at a premium.
In contrast, other sensors like magnet inductive or static Hall-sensors do not meet
these demands.
Each sensor in the series is available in various lengths and diameters and comes with
a choice of connections. However, functionally all sensors have the same characteristics. The stainless steel sensor housing is sealed at the front and is pressure resistant
(>200bar). A flat shaft is available or with a screw-in thread M12x1, M14x1, M14x1,5,
M16x1, M16x1,5, M18x1, M18x1,5, M22x1, 5/8-18UNF-2A. Customized dimensions
and thread specifications are possible.
To meet the particular requirements of hazardous areas we provide specialized types
t Wear-free due to its unique design
tprinciple
t Maintenance-free during Lifetime,
t therefore minimized TCO
t Unsusceptible versus external
t magnetic stray fields and machine
tvibration
t Operates down to zero speed
t Can not be damaged by faulty wiring
t Almost every target profile can
t be used
t A5S0 Sensors do not influence
t each other, no mounting distance
t in between is required
which are ATEX / IECEx certified, as well as being approved for other international
standards such as UL / CSA and EAC (Russia, Kazakhstan and Belarus Customs Union).
For Zone 0 or 1 we provide an intrinsically safe implementation in conjunction with our
Isolating Barrier D461, for Zone 2 a non-sparking (non-incendive) variation is available.
www.brau