Pleated & Cylinder Stainless Steel Filter Cartridges0 pages
SC Series Cartridge Filters
Pleated and Cylindrical 304 or 316
Stainless Steel Media
Applications
Caustic Fluids
High Pressure Fluids
Potable Water
Viscous Fluids
Oils
Air and Gases
Wastewater
Steam
Plating Solutions
Chemical Solutions
Corrosive Liquids
High Temperature Fluids
Maximum Operating Parameters
Differential Pressure
tForward
60 psid (4.14 bard)
2 psid (0.14 bard)
Reverse
Operating Temperature
Maximum Operating
Differential Pressure
Dimensions (Cylindrical)
Length
5 to 40 in. (12.7 to 101.6 cm) nominal
Outside Diameter
2.75 in. (7.0 cm) nominal
Inside Diameter
2.06 in. (2.95 cm) nominal
Flat Gasket OD
2.25 in. (5.72 cm) nominal
Filtration Area
.55 ft2 (0.051 m2) per 10 in. cartridge
Dimensions (Pleated)
Length
5 to 40 in. (12.7 to 101.6 cm) nominal
Outside Diameter
2.63 in. (6.67 cm) nominal
Inside Diameter
2.06 in. (2.95 cm) nominal
Flat Gasket OD
2.25 in. (5.72 cm) nominal
Filtration Area
1.7 ft2 (0.157 m2) per 10 in. cartridge
35 psid (2.4 bard)
Note: For special engineered designs, to achieve differential pressures up to
500 psid (34.4 bard) consult Critical Process Filtration.
Sanitization/Sterilization
There are many cleaning protocols designed to clean and
extend the life of the SC cartridges. These include steaming
and chemical and pressure washing. Ultrasonic cleaning
is recommended for pore sizes ≤ 5 µm in order to reuse and
extend the life of the element.
Pleat Protectors
Optional pleat protectors prevent accidental denting of the
pleated surface. They are made of stainless steel with ¼ in.
diameter perforations, and held in place by bending tabs at the
top and bottom.
Total Performance
Critical Process Filtration, Inc. is a vertically integrated manufacturer
of filtration products to industries in which filtration is considered
a critical part of the manufacturing process. We supply a complete
line of products and services to help you cost effectively satisfy all
your filtration requirements from a single source.
General Service Grade
SC Series Filter Cartridges have been designed to tackle the
toughest of filtering applications. All materials of construction are
304 or 316 stainless steel with a range of end cap configurations.
Fabrication is by welding and crimping. No adhesives or epoxy
are used for bonding. Grommet style flat gaskets are held in place
mechanically without adhesives. You can choose the pleated style
for extra surface area and extended life or the cylindrical form
for easy cleaning. Pleated units rated 100 µm or finer have an
underlying support layer of coarse stainless steel mesh to prevent
pleat collapse. SC cartridges are the perfect choice for high
temperature and high pressure applications and have excellent
compatibility. They are cleanable and reusable and offered in
retention ratings from 2 µm through 840 µm.
260 °C (500 °F)
"