GEAFlex ? Fully Welded Plate Heat Exchangers0 pages
GEAFlex – Fully Welded Plate Heat Exchangers
The best of both worlds
You no longer have to decide between shell-and-tube and plate heat exchangers.
GEAFlex is the answer. Because this heat exchanger combines the advantages
from both principles in a single unit and saves on two counts: in investment and
in operation.
The plate structure permits high performance density, meaning that smaller
heating surfaces are required, and effective, turbulent heat transfer is possible
even at low temperature differences and different flow rates. Pressure loss on the
tube side is low even with a high flow rate. Cleaning costs are noticeably lower
in comparison with conventional solutions.
The GEAFlex is therefore predestined for multiple applications: as condenser in
the chemical and petrochemical industries, in power station engineering, as
sugar juice preheater or as process, heating steam and overhead condensers
and in gas cooling and evaporation, etc.
In brief: the GEAFlex range offers you the maximum cost-benefit ratio in your
production or application.
Type-tested and quickly available:
nt For gas, steam and liquids
nt Large flow cross-section on the tube side
nt Can also be used in vacuum zones with large volume flows
nt Heat transfer surface areas from 12 to 800 m²
nt Up to 80 MW of condensation performance
nt For temperatures up to 250° C
nt Variable pressure limits: 10 / 16 / 25 bars
nt Type-tested to PED, other standards on application
nt Special designs are possible
Process Equipment Division
GEA PHE Systems