AT0000010 pages

fluid technology
temperature sensors 1600
design

Ø38 x 118mm

temperature

operating range

-40 to +300°C

temperature range from -40 to +300°C
M12-connection socket for PT100 resistance
thermometer
analog output with adjustable start
and end point
turn-on and turn-off delay separately
adjustable
test function – simulation of the adjusted
switching functions without connected
resistant thermometer
peak hold function for the display
self monitoring function: overload, breakage
and sensor function

intelligent temperature sensor, membrane keyboard, USB opto interface

description
The YT35 temperature sensor from ipf electronic offers a
high level of operator comfort.
The device has 2 outputs. Although output 1 relates to a
freely-programmable switching output, for output 2 a selection can be made between an analog output, a switching
output or an alarm output.
Devices with an 8-pin connection have both 2 switching
outputs and an analog output available.
Among other things, the switch points, release positions,
output logic and time delay can be programmed via the
membrane keyboard.
The sensor has an M12-connection for a PT100-resistance
thermometer and can be used up to a measurement temperature of 300°C. The PT100 and the screw-in sleeves that
fit it can be found on page 4 of this data sheet.
A quick exchange is enabled thanks to the screw-in sleeves,
because the resistance thermometer is separated from the
process by the mounting connection. The temperature measurement of the PT100 takes place on the first two centiipf electronic gmbh

Kalver Straße 27
D-58515 Lüdenscheid

meters of the test prod.
The sensor has an optical interface with which, in addition,
all adjustment parameters can be adjusted and changed via
a PC or notebook.
For dynamic measurements, the display and the analog output are equipped with an adjustable damping function. Following installation, the sensor body can be rotated by 350°
and the sensor display can be rotated by 180° by means of
the software.
The test function offers a simple and quick possibility to
check the function of the device and/or the analysis which
have been switched on. In connection with this, each temperature value of the temperature range can be “simulated”
through the operating buttons or by operating the PC. The
device behaves as if a temperature sensor were connected.
application examples
temperature monitoring in furnaces and machines for
fluids and air

Fon +49 (0) 2351 / 9365-0
Fax +49 (0) 2351 / 936519

www.ipf.de
E-Mail: info@ipf.de

subject to alteration!
Version: January 2010

1