Compact E10000 pages
Spreading Technology
c u t t i n g
r o o m
t e c h n o l o g y
Introduction of topcut-bullmer
spreading technology
German engineering is known in the
world for it’s design combined with
outstanding functional characteristics.
The users benet from high advantage
in production, high efciency and availa-
bility and low maintenance costs.
Spreading Technology E
The wide range of fabrics and at materials which are brought to bear differ
extensively from each other. Topcutbullmer therefore follows two objectives
with his developments: First to built
spreading machines, which can handle
a wide spectrum of fabrics and second
to enable them to cope with extreme
needs.
In the area of material handling topcutbullmer supports two ways. The fabric
rolls are lead via a bar, which allows a
very gentle winding. The bar can be
powered respectively not driven. The
alternative consists in a belt-driven cradle
which provokes the perimeter of the roll.
This technology offers the advantage to
lead the roll without any attachment.
All standard versions of the machines can be upgraded by several options to meet the detailed needs of
every plant. By this means each machine can be expanded even after installation.
Generic features and supplies
• Distortion-free, light sectional steel chassis.
• Four-wheel drive with „Vulkollan“ wheels.
• Stable lateral guidance with 4 lateral guide rollers at
the angle bracket on the operator side.
• 3-phase traction drive with frequency control.
• Machine reversing speed can be adjusted
separately.
• Automatic pre-centring of material beginning during
threading.
• Electronic edge control, manually adjustable.
• Fault-cutting-off-mode with automatic synchronous
material rewinding.
• Automatic return drive of spreader to the loading
position at fabric end.
• Motor-driven lift for the cutting and zigzag unit, with
automatic height adjustment at ply height.
• Control handle for continuous manual adjustment of
the spreading speed.
• Power and air supply with cable drag chain.
• Encoder for measuring and controlling for drive and
spreading length by means of a tooth belt at the table.
• Integrated, all-in-one controller opposite the operator
side in externally blower housing.
• 4-fold emergency stop on both sides and at the front
and back of the machine.
• CANBUCON 1 controller on free programmable
basis, control panel with display, control in CAN-BUS
technology.
(CANBOCON 1 controller)
"