Vicork C310 pages

Vicork C31

Vicork is an eco-friendly insulator, made from a combination of recycled rubber tires and portuguese prime material cork, is a cost
effective and versatile product. Designed for floor installations, the Vicork is placed between the concrete and the final floor finish.
A quick solution for pro-audio, industrial, residential and commercial applications.

Product - The dimpled (wave textured) agglomerated cork underlay for healthy flooring
Moisture - Agglomerated cork
Features:
- Prevents Mould Grouth
- High Durability and Long Term Resilience
- Environmental friendly (100% natural and sustainable)
- Increases Floor Thermal Insulation
General Installation Instructions - The following installation instructions are recommended by Vicoustic, but are not intended as a
definitive project specification. They are presented in an attempt to be used with recommended installation procedures of the flooring
manufacturers.
Environmental Conditions - Temperature>10ºC / Room moisture content<75%
Subfloor - All subfloor work should be structurally sound, clear and level. The moisture content of the subfloor should not be more
than 2.5% (CM) by weight measured on concrete subfloors.
Insulation vapour barrier- A p.e. insulation vapour barrier covering the entire flooring area, minimum 50mm wide vertically around the
perimeter of the entire floor MUST be installed prior to the ViCork C31.
Install by overlapping (minimum 100mm) the p.e. foil, and use an adequate tape to adhere/fix it, if necessary. After completion, p.e.
foil should cover the entire concrete area without gaps. Never mechanically fasten the p.e. foil barrier with screws, nails or staples as
this will severely diminish the performance of the insulation barrier.
Installation Instruction for ViCork C31 - Unpack the ViCork C31 at least 24h before the installation and store it in the room where the
installation will take place. Cut the C31 to desired length and install directly over the entire floor pulled 30mm up the walls with crown
of the rolled materials up (ViCork label side down), removing all traped air. After completion, the C31 should cover the entire flooring
area without gaps and with joints butted tight and preferably taped.
Final Flooring - Always follow manufacturers recommended installation instructions.
Important Notes - Never mechanically fasten the ViCork C31 to the flooring floor as this will severaly diminish its acoustical value.

Main Info

Ref: U01047