BKS 8000 pages
®
Cable Pusher
BKS 800
Have you ever been faced with the task of pulling
cable along meandering courses, through street
under crossings or in narrow ducts? If so, you will
know how soon the stress limit of the cable being
pulled is reached and how soon you will have to
fit a connection piece.
In order to avoid premature cable cutting and
fitting of connection pieces, it is advisable to use a
Bagela Cable Pusher in front of a bend, which will
reduce cable stress and allow longer cable lengths
to be pulled.
Each use of the Cable Pusher BKS 800 will save
the cost of fitting one connection piece.
No extra time will be squandered for
- cutting the cable,
- moving the cable drum.
- excavating a connection pit,
- barring of the connection pit.
- refilling the connection pit.
Function:
The cable passes over two pairs of tapered pulleys, which are driven by electric or hydraulic motor. Two counter
pulleys press the cable into the grooves of the two driving pulleys, thus ensuring adequate friction. For effective
power transmission the tapered driving pulleys are consisting of a special, highly elastic, tough and wear-resistant
rubber material with a high coefficient of friction.
The gap between the tapered pulleys can be varied, so that cable and tubes of 30 to 180 mm in diameter and three
single lead 20 kV cables in one strand can be pushed.
After the cable has been laid in place, the press-on unit can be removed and the cable taken out and put aside. As
the machine is extremely low (340 mm), there will be no unwanted bends in the cable after pushing.
Specifications are subject without notice. Output details are depending on use conditions.
Bagela
®
3
"