1313 Plus Advanced 12V Spike Suppressor0 pages
NEW ACT-1313-PLUS
COMBINED 12VDC FALSE ALARM
FILTER & LED POWER MONITOR
Now you can easily identity and eliminate causes of false alarms by
fitting the new ACT-1313-PLUS to control panels and PSU’s.
Designed by retired alarm
troubleshooting expert David
Grant for ACT Meters (UK)
Ltd, the ACT-1313-PLUS not
only eliminates false alarms
caused by induced AC and
RFI interference but can also
identify cable faults supplying
DC power to motion detectors
or any 12v detection devices.
The ACT-1313-PLUS connects
directly between the control
panel or PSU’s auxiliary 12VDC
supply to motion detectors
or other powered detection
devices. Twin terminal blocks,
2xRed+, 2xBlack- enable power
cables to be grouped and
connected easily.
any potential DC power
overload or low resistance fault
on any cable connected. Green
shows ‘no faults’ whereas Red
indicates ‘fault exists’. If the red
LED is lit, simply disconnect DC
power cables one at a time to
identify the troublesome circuit.
How simple is that!
Installing the new ACT-1313PLUS to your control panel and
PSU’s as standard enhances
your company’s reputation over
competitors by eliminating false
alarms as well as saving your
valuable time and repeat call
outs by instantly identifying
power cable faults!
If the red LED is lit with all
power cables removed, this
indicates that the panel or PSU
DC Voltage is insufficient to
power motion sensors and other
detection devices effectively
against false alarms.
Induced AC is eliminated and
RFI attenuated by up to 60dB
on all DC power cables
connected to the ACT1313-PLUS preventing
false alarms. In
addition, a bicoloured LED will
instantly indicate
For more information contact ACT sales or technical support
on 01744 886660 or sales@actmeters.com