gensys200 pages

paralleling

all-in-one

GENSYS 2.0
All-in-one genset control
and paralleling unit
with integrated PLC
•t Compact “all-in-one” module
•t I/O flexibility
•t Internal logic sequences, programmable
by equations and the Easy PLC software
•t New multi-function graphic display
•t Isolated serial ports: RS485, 2 CAN bus,
•t SD card reader, Ethernet
•t J1939 communications with electronic engines
•t Fully compatible with all speed governors and AVRs

The GENSYS 2.0 is a control unit PROGRAMMING BY EQUATIONS
designed for generator electrical The GENSYS 2.0 controller is a real PLC unit where equations and
sequences can be programmed directly by the user with text editor
panels.
This “all-in-one” unit combines
all necessary functions:
•t Three phases mains failure
•t Engine start/stop and
protections
•t Alternator control and
protections
•t Mechanical parameters display
•t Electrical parameters display
•t Genset synchronization
•t Load sharing and kW control
•t Load sharing and kVAR control
GENSYS 2.0 is configurable via
its front panel or via a PC with
CRE Config software. It has an
embedded Web site which is
password protected.
The GENSYS 2.0 controller has
analog load sharing lines and
is compatible with most of the
types of analog load sharing
modules.
www.cretechnology.com

software or Easy PLC software.

INPUTS / OUTPUTS WITH NO LIMIT

The number of inputs/outputs that can be added is one of the most
important on the market. Extension modules (DIN rail mounting) can be
added on the CAN bus. This extends a large number and a large diversity
of inputs/outputs up to 128 digital inputs, 64 digital outputs, 44 analog
inputs, 32 analog outputs and CANopen standard module.

MINIMUM OPTIONS

The GENSYS 2.0 is offered with a minimum of options to fit all types of
application without expensive add-on packages. The standard GENSYS
2.0 unit is recommended for all types of power plant, from 1 to 32
generators.
For specific needs, the following options are available :
•t Mains paralleling
•t Phase shift compensation (ie: Dyn11)
added
•t External start module management
EQUATIONS :
value

INTER-UNIT ISOLATED CAN BUS

The GENSYS 2.0 features an isolated CANbus
dedicated to inter-module communication
(dead busbar management, static paralleling,
kW and kVAR load sharing...).
CANbus technology provides high reliability
communication while maintaining low wiring
cost and complexity.

Embed your knowledge!

GENSYS 2.0 integrates a real PLC
unit in which user equations and
sequences can be written using a
simple text editor or graphically
designed using the Easy PLC
software.