2000 Series Model LED Explosion-Proof LED Warning Light0 pages
FEDERAL SIGNAL CORPORATION
Explosion-Proof
LED Warning Light
2000 Series Model LED
The 2000 Series Model LED beacon, with XLTTM technology, is a
visual signal warning light for use in hazardous locations requiring
ATEX approval. The beacon can produce three light patterns depending on the configuration of a field selectable jumper wire or remote
contact closure. The light patterns are steady-on, slow flash or rapid
flash. An optional telephone initiation feature also allows the beacon
to flash when telephone ringing voltage is present.
DESIGNED FOR USE IN ATEX
ZONE RATED ATMOSPHERES
•t Super bright output
with XLT LED Technology
The 2000 Series LED beacon is sealed from dust and water by a
nitrile rubber o-ring. All exterior cast aluminum surfaces are finished
in powder coat paint and external hardware is manufactured from
stainless steel to resist corrosion. Available signal colors are Amber,
Blue, Clear, Green, Red and Yellow.
TM
•t 3 remotely selectable
flash patterns
•t 50,000 hour lamp life
The 2000 Series LED beacon is externally powered by 24VDC or
110-240VAC source. All AC powered units feature a switch mode
power supply that accommodates a wide input voltage range without
requiring any additional configuration from the user. The current
consumption from the beacon is less than 500 mA and the in-rush
current is low enough to allow PLC initiation without the use of an
external relay. Screw type terminal blocks are provided for field
wiring on all units.
•t Available in six colors
•t Ex ‘e’ terminal chamber available
•t AC and DC voltage ranges
•t Approved for use in Zone
1, 2, 21, 22 Atmospheres
All variations of the 2000 Series LED beacon feature a four entry
fixture to allow cable looping. These cable entries are metric
(M20 X 1.5) but other configurations are available upon request.
ATEX
ttt
Operating t Flash Rate/t
ModeltVoltaget Currentt Minutet
Max In-Rush
Current
LEDt
WA
RRANT
Y
60-80 t
1.75A for 5.00mS
110VACt
0.22 ampst
60-80 t
2.00A for 0.25mS
LEDt
5
0.50 ampst
LEDt
y
yr
24VDCt
240VACt
0.13 ampst
60-80 t
2.00A for 0.25mS
Specify color: (A) Amber, (B) Blue, (C) Clear, (G) Green, (R) Red or (Y) Yellow
"