CAN-Bus Tester 20 pages
CAN-Bus Tester 2
Features:
Bus systems:
– CAN, CANopen, DeviceNet, SAE J1939
Baud rates (5 kbit/s ... 1 Mbit/s)
Measuring of the signal conditions:
– General quality level (0 ... 100 %)
– Disturbance-free voltage range
– Rising and falling edges
– Oscilloscope with message frame analysis
Continuous monitoring
Online trigger (real-time monitoring of the bus for logical and physical errors)
User-friendly protocol monitor
Testing of cables
– Short-circuits, interruptions, loop resistances, cable length
Straightforward application software:
– Management of measurements (measurement types, measuring points, measuring times)
– Comprehensive test record, broad variety of export functions
– Automatic evaluation of the measurement results
The CAN-Bus Tester 2 constitutes a universal measuring instrument for the commissioning, analysis, monitoring, troubleshooting and service/maintenance of CAN bus plants.
Typical problems which occur during the operation of CAN bus plants, such as node failures, faults
in the communication or complete standstill of the plant, often have their origins in the physical bus
characteristics. The CAN-Bus Tester 2 provides an overview of the signal conditions on the bus,
which helps you locate and rectify frequently occurring error causes without unnecessary delay.
You can already ensure a correct bus cabling and verify its transmission properties when setting up
the plant. You can also perform comparing measurements directly on the running plant over its life time and thus prevent downtimes.
Fields of application:
Commissioning of CAN bus plants
Wiring test, module check
Service/maintenance of CAN bus plants
Troubleshooting and analysis of the physical
bus characteristics
Development of CAN modules
Final testing in the production
GEMAC - Gesellschaft für Mikroelektronikanwendung Chemnitz mbH
Zwickauer Straße 227
D-09116 Chemnitz
Tel.: +49 371 3377- 0
Fax: +49 371 3377- 272
www.gemac-chemnitz.de
Seite: 1/2
Field Bus Testing Devices
– Bus status, bus traffic load, error frame counter (active error/passive error)