OZMA0 pages

OZMA Series Vertical Hammer Style Shredders

The OZMA Vertical Hammer style shredders are mainly applied in applications where
further processing is required from pre-shredded metal scrap from a slow speed, high
torque two shaft shredding system. These machines aggressively size reduce and
densify pre-shredded material whilst liberating the various different fractions and allow for
better downstream separation and reduced transport costs, The breakers or smasher in
the upper part of the chamber break apart the material until it is small enough to enter the
gap between the milling rings and chamber liners. When the material enters the second
stage, the milling rings impact, grind and roll the material into clean fragments. When
crushed into small enough pieces, the balled up material falls into the lower chamber. It
is then ejected by the discharge paddle. The three stages above create a product that is
both clean and high in bulk density suitable for transportation.
Typical Applications Include:

Electronic Scrap – WEEE Directive Materials

Aluminum – Castings, Profiles, UBC’s etc.

Scrap Steel – Pre-shredded steel sheets, metal drums etc.

ELV’s (End of Life Vehicles) – Pre-shredded vehicle bodies

SLF (Shredder Light Fraction), ASR (Auto Shredder Residue)

1