M800 Speedswitch - underspeed motion monitor0 pages
Product Information
BRAIME
M800 Elite Speed Switch
M800 Elite Speed Switch
Monitors Rotating Machinery for Dangerous Underspeed Conditions
APPLICATION
The M800 Elite Speed Switch is designed to detect belt slip, belt
underspeed, stop motion, low speed or zero speed on bucket
elevators, conveyors, airlocks, mixers, fans, grinders and many
other rotating machines. Totally sealed and simple to calibrate, the
M800 Elite works in the harshest of conditions.
METHOD OF OPERATION
An inductive sensing device located in the nose of the M800 Elite
enclosure will detect a metal target. This target can be an existing
bolt head or device attached to a shaft. During installation the M800
Elite is set to the normal machine shaft RPM by calibrating with the
magnet provided. The internal microprocessor sets the alarm and
shutdown relays. Two M800 Elite models are available:
Model M8001V10C may be used either as a dual trip unit with an
alarm at 10% below set speed and a shutdown signal at 20% below
set speed, or a single trip giving a shutdown signal at 20%.
Model M8002V10C may be used either as a dual trip unit with an
alarm at 5% below set speed and a shutdown signal at 10% below
set speed, or a single trip giving a shutdown signal at 10%.
A simple calibration facility allows either model to be programmed to
give a start up delay of up to 15 seconds, while simultaneously
calibrating for normal running speed. If required, the M800 Elite has
an additional pulsed output, which can be connected to display
actual shaft RPM on a PLC or speed display.
FEATURES
► Universal Voltage (24 – 240 VAC/VDC)
► Dual Set-Points for Alarm and Shutdown
► Totally Sealed Construction: Submersible
► Microprocessor Accuracy & LED Indicators
► Built In Conduit Adaptor (1/2” NPT)
► CSA Class II, Div. 1 Groups E, F & G Approved
► IP67 Protection
M800 Elite
Installed on Shaft
with Whirligig®
PART NUMBERS/ACCESSORIES
► M8001V10C
M800 Elite (10% and 20% Relays)
► M8002V10C
M800 Elite (5% and 10% Relays)
► SM1
SpeedMaster™
► WG4A-BR
Whirligig® Shaft Sensor Mount
► MAG2000M
Mag-Con™ Magnetic Connector
► TACH3V5
Tacho Speed Display
Whirligig® with Optional
Mag-Con™ Connector
Tacho
Speed Display
Detailed specification, wiring diagrams and installation/operating instructions available upon request.
4B BRAIME ELEVATOR COMPONENTS LTD Hunslet Road, Leeds, LS10 1JZ, UK
Tel:+44 (0) 113 246 1800 Fax: :+44 (0) 113 243 5021 4b-uk@go4b.com
Whirligig®: U.S. Pat # 6,109,120
Mag-Con™: U.S. Pat # 6,964,209
Please refer to instruction manual for correct installation.
Information subject to change or correction. Jan 2015
www.go4b.com
"