AquaPool Swimming pool heating system0 pages
AquaPool
Swimming pool heating system
Application
Swimming pool water heating. Simple, strong, compact and
highly reliable, the AquaPool is designed to efficiently reheat
and maintain temperature of water in swimming pools of all
dimensions and capacities from primary heat source such as
boiler, solar installation, heat pump etc.
Standard design
Complete packaged module including:
Stainless steel or titanium plate heat exchanger, for operation
with sea water or slightly corrosive water (balneo-therapy,
thermal spring water), EPDM clip-on gaskets.
Primary circuit:
– Single headed pump, electrically wired
230 V / 1PH/ 50 Hz, with built-in winding overload protector
– Isolation valves on primary inlet and outlet
– Non return valve on primary pump outlet
– Black steel pipe work, epoxy painting coated
Secondary circuit:
– PVC pocket for electronic controller temperature sensor
– 2 PVC three-piece connectors for swimming pool circuit
piping
Electrical panel: IP 55 plastic control box including:
– Electronic controller, with front mounted display
– On/off switch
– Power on light
– Terminal block
AquaPool is fully assembled, electrically wired, pressure tested
and calibrated at the factory prior to dispatch.
AquaPool
Installation and operating principle
Installation is simple and easy, since only a required
connection of:
– Primary circuit to heating pipe work, through a circuit
separation bottle
– Secondary circuit to swimming pool filtration circuit
– Electrical supply 230V/1Ph/50 Hz + E to control box.
Operating principle:
– The electronic thermostat sensor controls the swimming
pool inlet water temperature
– The primary pump is switched on and off according to the
controller demand
– On/off control
All components are easily accessible and removable, resulting
in very low operating costs.