60mm (T) Geared Synchronous Motor0 pages

SYNCHRONOUS MOTOR FAMILY
Series 60mm (T) Geared Synchronous Motor
Torque Range:
Output Speed:
Poles:
Insulation Class:

Up to 250 oz-in [1765 mN-m]
.25 to 300 RPM
T Series 24 poles; TA Series 20 poles
Class A (105°C)
4 leads 22AWG (approx. 12 inches [304.8
Lead Wire:
mm])
Operation Ambient Temp:
-10°C to +40°C (approx.)
Zinc Die Cast - AGMA 7 Standard with
Gear Unit:
hardened steel gears
Shaft Bearing:
Sleeve Bearing
E53578(N), Component-Impedance
Protected Motors,
Recognition:
115Vac Standard Rotor
Card No. 42576, Motors and Generators,
Certification:
115 Vac, 60 Hz, Standard Rotor, 7 watts max.
Note: Typical data subject to change without notification

Reversible, permanent magnet synchronous series T geared motors are available in a wide range
of speeds. The gear trains are the most rugged with a maximum recommended loading of 250
oz-in [1765.4 mN-m] at 1 RPM. All gears are hobbed to AGMA 7 quality. Pinions are extruded
from a special steel with a modified long addendum tooth form to provide higher strength. Pinions
are held to the same AGMA 7 quality level as the gears. Both pinion and gear teeth are case
hardened for wear resistance and rotate upon hardened and ground steel studs.
Standard motors are 115V, 60Hz but other voltages may be specified. Sleeve bearings are
standard. Capacitors are required for operation and must be used in the circuit even if the motor
is used in a unidirectional mode.

1

Hurst 1551 East Broadway Street Princeton, IN 47670
MOTOR SPECIFICATION SHEET