ISOGEN ®0 pages
PRODUCT SHEET
ISOGEN®
Create Isometrics from Any Isogen-ready CAD System
Isogen® is the most widely used software for the automated generation of piping isometric drawings. Most commercially available 3D
design solutions for piping systems either use Intergraph® Isogen
Isogen Workflow
3D Piping
Design
directly or support the Isogen data file formats – the Piping Compo-
IDF
PCF
nent File (PCF) or the Isogen Data File (IDF).
Isogen
If your system produces IDFs or PCFs, but does not have Isogen
bundled with it, then you need Isogen. This will enable you to turn
your valuable piping data into piping isometric drawings.
TEAM AND SOLO EDITIONS
Choose the licensing model that best meets your needs:
•tIsogen Team Edition enables you to process an unlimited num-
ISOGEN CONFIGURATION
Reports
Two tools are supplied with Isogen Editions to help configure the
required output.
•tI-Configure includes the new Isogen Configuration panel, which
offers a new visual approach to setting up Isogen. You can alter
ber of pipelines, from any source, into drawings. This option is
the settings and see the results immediately before proceeding to
more cost-effective for larger projects, or if you plan to use Isogen
run your drawings through Isogen.
for more than one project.
•tIsogen Solo Edition offers a counted pool of licenses that decreases each time Isogen runs a PCF or IDF. You can buy license
tokens in batches of 500 or 1,000, making sure you have enough
for the project, and allowing for any testing, revisions, or re-runs.
This is a cost-effective, low-risk way to start using the software. It
is ideal for small projects.
INTERACTIVE AND AUTOMATIC MODES
ISOGEN provides two mode choices. When installing either ISOGEN
Edition, you can install one or both modes:
•tIsogen-R (formerly known as I-Run) provides an interactive
graphical user interface (GUI) through which you can select the
input files and view the resulting output.
•tIsogen-S (formerly known as I-Serve) runs automatically as a
service. Isogen-S monitors a folder for IDFs or PCFs, running them
through Isogen when new files are detected.
•tSymbol Editor enables you to redefine the 2D shape used by
Isogen to represent certain fittings on the final isometric.