Rotators for Crane Attachments0 pages
KINSHOFER Rotator Line
Product Features
KINSHOFER manufactures rotators for truck loaders, excavators and logging
operations. Years of experience in designing rotators and hydraulic load handling
equipment guarantee high efficiency, long lasting rotators, specially tailored to meet
your requirements.
The gear-type design ensures a very compact and powerful rotator. The precision
control and braking ability is especially appreciated by operators. A grapple does not
rotate unexpectedly when digging, even under maximum load, and there is no need for
stability compensation when handling longer lengths of timber... These are only some
of the many working situations where operators appreciate the advantages of using
KINSHOFER rotators.
KINSHOFER Rotators are the solution.
Features of KINSHOFER Rotators
The rotator head is made of spherically cast iron or
forged tempered steel, depending on operational
requirements
Upper and lower connections are available in a variety of
dimensions and are standard. Kinshofer carries
upper suspensions for all current makes and models of
cranes. Rotator heads with pin connections are equipped
with steel bushings
The pressure relief valve, integrated in the rotator
head, allows the rotator independence from
the hydraulic system of the crane or excavator –
where an extra pressure relief valve does not need
to be installed
All seals are specially designed for the application.
All biodegradable synthetic oils are perfectly
suitable
A very high degree of sealing between the
distributor and rotor unit results in minimal
internal leakage. Powerful drive and braking
moments are therefore possible, even at high
oil temperature
The rotor unit is made of high quality tempered
steel and the outer surface is hardened through
a nitrate-coating
Generously dimensioned roller bearings
guarantee absorption of rated pressure and
tension loads and tilting moments
The forged, one-piece flange shaft is made of
durable tempered steel
Horizontal and vertical hydraulic connection of the
attaching equipment is possible
Oil passages for a single hydraulic circuit are standard and generously dimensioned for
high capacity flow. Connection with standard fittings is possible because flange and
rotator shaft are a single unit, which also means there are no seams between flange
and rotator shaft. Rotators with four oil passages are also available