MC-4SA0 pages

Stage Controller
MC-4SA

MultiAxis

Servo Amplifier System

Specifications
AC power input (User-selectable):
Motor control input voltage:
Encoder supply voltage:
Max output power (Standard):
Output voltage range:
Slew rate:
Voltage gain (Av):
Standard cabling:

110/220 VAC
±10 VDC across 300 K ohms
+5 VDC
6 Watts
±12 VDC
8 V/µS, max.
1.2
CA10-10-3: 3 ft. motor extension cable
CA10-10-6: 6 ft. motor extension cable
CA10-10-9: 9 ft. motor extension cable
186381-02: 6 ft controller amplifier interface cable
Call for information on additional lengths

MULTI-AXIS|micropower
The MC-4SA is a multi-axis motor drive amplification system
designed for use in systems where low power micro motors
are required for a particular application.
The MC-4SA was designed for interfaceability to the National Instrument™ controllers. The MC-4SA interface connectors allow versatile connectivity based on the
application and controller being used. All 4 axes may be
accessed through a single cable.

Simple Connectivity
All of the difficult interfacing problems have been taken out
of the hands of the user. For example, setup is simple; connect one end of the 68 conductor cable to the controller
and the other to the MC-4SA; plug in your MicroMini™
stage and you are ready! No external power supply connections, no multi-wire motor connections.
The MC-4SA also features a number of built-in protective devices and signal enhancement circuits such as;
•
•
•
•
•

Supply Rail Monitoring (SRM)
System status monitoring
Kickless Balanced Power Supply
Encoder conditioning
Reversible motor polarity

Features
• Fully compatible with all MicroMini™ stages
• 110VAC 60Hz/220VAC 50/60Hz operation
• Built-in limit-sensing logic
• Front panel axis fault lights
• Axis enable switches w/illuminated status lights
• Compact design
• Versatile multiple-controller interface
• On-board encoder conditioning
• Joystick Input
• Linear Encoder Inputs (Differential)
• Auxiliary I/O connector for ease of wiring
• Easily accessible rear panel mounted fuses
• 19” Rack Mountable or Desktop design
• Fully LabVIEW™ by National Instruments compatible.

National Aperture, Inc. can provide custom
electronic and mechanical design services in
order to integrate the MC-4SA into your
application.

The information contained in this data sheet is subject to change without notice. Critical dimensions or specifications should be verified with our technical support staff.
National Aperture, Inc. - 16 Northwestern Dr. - Salem, N.H. 03079-4810

- Tel. (800) 360-4598 - (603) 893-7393 - FAX (603) 893-7857 -

www.nationalaperture.com/www.naimotion.com

41