Catalogue 2016 - QuantaDat/nSens multi sensor transmitter system0 pages
QuantaDat / nSens Multisensor-System
QuantaDat / nSens
QuantaDat Multisensor-Transmitter
This modular designed transmitter ,with multi sensor technology, is used as a display and
signal output unit with 4 sensor channels and 4 analogue outputs. This allows the
management of 4 measurement points by only 1 transmitter. The sensor identification is
made automatically and the channels can be assigned and configured using the onboard
menu.
The integral climatic processor (Mollier chart) enables display and output of values such
as dew point temperature, absolute humidity, specific enthalpy, mixing ratio etc. An
RS-485 interface is integrated as standard. Bus interfaces and relay switches can be
assembled with modular configuration.
Technical data
QuantaDat and QuantaDat-RL
Power supply
Power consumption
Display
Analogue outputs
24V +/- 15% AC or DC (galvanic isolated)
max. approx.3W
Graphical display with LED backlight
4 scalable analogue outputs,
current 0/4..20mA or voltage 0/2..10V
Interface provided
2 relay contacts (for version QuantaDat-RL)
ABS - lid blue RAL 5014, bottom grey RAL 7035
IP54
0 to 50°C
Digital outputs
Housing material
Protection class
Working temperature
nSens probes
An integral component of the system is the digital nSens-HT humidity/temperature and
nSens-T temperature sensor which works is over the whole measurement range with
high accuracy and linear response characteristics . The calibration data is stored direct
onto the sensor. The verification/calibration is performed by PC using the nSoft-CAL
software. These plug-in probes are quickly replaced on site and the newly calibrated
system may be put back into use again quickly, maintaining highest accuracy.
Technical data
Measurement range
nSens-HT-ENS
nSens-HT-ENS (humidity & temperature probe)
nSens-T-NBS (temperature probe)
Humidity
Temperature
Humidity
Temperature
Measurement
accuracy
Number of cal. points
Digital output
Housing material
Sensor protection
Working temperature
nSens-T-NBS
0 ... 100% RH
-20 … +80°C
typ.+/-0.5%...+/-2.5% RH
typ. +/- 0.1K…+/- 0.2K
depending on on measurement range
Humidity
13 points over the full meas. range
Temperature
2 points over the full meas. range
Novasina Bus-system
PVDF black
Standard - polyethylene dust filter (nSens-HT-ENS)
Plastic protection cap (nSens-T-NBS)
-20 to +80°C
Applications:
Monitoring and control of climatic processes in clean rooms, climatic
chambers, mini-environments etc.
Climatic control in paper- and textile productions
Climatic monitoring and control in laboratories, calibration rooms etc.
Optimisation of combustion processes in gas turbines
Monitoring and control of climatic parameters in storages, server rooms
and many more…
Doc. 005221.00
General catalogue AIR 2016
page 11 / 37
"