HI 200DNWM0 pages
Model HI 200DNWM
DeviceNet Weigh Module
Series B
Applications
PROCESS WEIGHING
•t Batching/Blending
•t Filling/Dispensing
•t Level-by-Weight
•t Check Weighing
•t Force Measurement
Features
WAVERSAVER®
•t Ignores vibration on and around
scales
C2® Electronic Calibration
•t Electronic calibration without test
weights
THE BUTTON
•t One step calibration with C2 load
cells
TWO SET POINTS
•t TTL Level
CONFORMANCE TESTED
The HI 200DNWM is a general purpose
weigh module designed specifically to the
DeviceNet Open Network Standard. Its'
many features, including "calibration with
the push of a button", have set the norm for
all future DeviceNet weighing products.
FEATURES
•t The HI 200DNWM Series B now allows
easier programming and increased flexibility
through features such as:
•t A "Command Interface" for easy access to all
parameters without the use of explicit
messages
•t A choice of outputs with selectable decimal
point location
•t A selectable update rate of 10 or 55
samples per second
The HI 200DNWM supports up to eight C2®
certified load sensors and provides power to
scales with up to four 350-ohm standard strain
gauge load cells, load sensors or load points. It
receives and digitizes the weight signal with over
one million bits of resolution, and transmits the
selectable Gross, Net and Tare weight data over
the DeviceNet Open Network interface to other
devices. Data is transmitted at three switch
selectable baud rates of 125, 250 or 500
kilobytes per second. The DNWM acts as a slave
on the network and supports a polling I/O
exchange mechanism. Two on-board bi-color
LEDs provide module and system status for
troubleshooting.
SET POINTS
Two independent TTL level outputs provide set
point capability each with separate deadbands
and preacts for control capabilities in a variety
of weighing applications.
C2® ELECTRONIC CALIBRATION
C2 enables electronic calibration of the weigh
system without test weights. This saves system
start-up costs and aggravation. Of course, even
if C2 certified load sensors are not used, the
system can still be calibrated the slow, traditional
way using certified test weights.
WAVERSAVER®
WAVERSAVER eliminates the effects of unwanted
plant vibration on or around the scale by
permitting the weigh module to “see” through
the unwanted vibration signals - as low as
0.25Hz - while yielding a stable actual reading.
THE BUTTON®
With one push of a button the weigh scale
module automatically calibrates the weighing
system, making it ready for use. This saves
system start-up time costs and aggravations.
ADDITIONAL FEATURES
This module comes with a disk containing the
Electronic Data Sheet (EDS) and a user's
manual. This product is available for dual
stacking in an instrument cabinet, on standoffs, or
on din rail, It is also available with a summing
card packaged in a painted steel NEMA 4 or
Stainless steel NEMA 4x junction box.
www.hardysolutions.com • 800-821-5831
"