Closed-loop Hall effect current sensor 5 A, ø35 | SCB12-5A0 pages
Shenzhen Socan Technologies Co.,Ltd T: 86-755-86242301 F:86-755-86242302 URL: www.SZSOCAN.COM
SCB12-5A Hall Current Transducer
一、Introduction
SCB12 series is close loop Hall-effect current sensor develop on Hall effect principle. Because the input
signal is weak and the sensor is round perforation measurement mode, we adapt in shielding design to
overcome the impact of interface.
This product is widely used in power supplies system, servo drive system, photovoltaic systems and leakage
current measurement, is an ideal energy saving and optimization control parts.
二、General Data:
1、 Primary nominal r.m.s. current(Ipn)5A
2、 Output voltage±5V
3、 Window diameter ø35
4、 Accuracy: ±1%
5、 Load resistance>=10KΩ
6、 Input overload2 In
7、 Bandwidth±DC-150KHZ
8、 Response time≤1µS
9、 Withstand voltage3KV DC
10、 Supply Voltage DC ±15V
11、 Current consumption<20Ma
三、Sensor structure
1. close loop structure as a whole set, its shell is made of engineering plastics. Upright installation.
2. the lower part of the sensor is power supply and signal output pin.
3. the product uses epoxy encapsulation method, suitable for high temperature and humid workplaces.
四、Installation
Sensor installation: vertical loading, window diameter is ø35.。