Optical tables and Breadboards0 pages

Honeycomb Table Topst
1

1HT

Optical
Tables
2
Brackets
& Rails
4
5

Optical
Mounts
6

Optical
Positioners
Base
Positioners
Translation &
Rotation
Stages
7
9

Motorised
Positioners &
Controllers
8
Fine
Adjustment
Screws
OptoMechanics &
Sets
10
Light Test &
Measurement
Instruments 11

The Concept of Closed Top Honeycomb Tables
Real Closed Top – no way for liquids or tiny particles to get in. There
are only the holes you do use. Make “new” holes by yourself. If You
need a hole, clear it of the plug with a pencil or any similar item. Seal
the no longer needed hole with the self-solidifying plastic mass again.
In order to facilitate composition of optical schemes, we pre-set the
plastic plugs of two colours, so that they form a coordinate grid with
a mesh of 100 mm.

Fax: +370-5-2651483

pressure to a honeycomb core, using a special
epoxy resin. Thickness of the skins depends on
the dimensions of the table top.
The top skin has a pattern (grid) of M6 holes
spaced by 25 mm with ±0.1 mm accuracy. It allows to make very quick experimental setups, and,
at the same time, ensures a high level of precision
and reproducibility. The surface of the top skin
is ground to flatness of ±0.1 mm over any 1 m²
area over the entire surface. The bottom skin is
coated in a firm decorative coating.
Our standard honeycomb core is made of
0.25 mm corrosion-resistant plated sheet steel.
A special composition of epoxy resin guarantees
adhesion, rigidity, stability and damping corresponding to highest requirements.
The side-walls of the table top are made of a
special acoustically hollow plastic which damps
acoustic vibrations. The side-walls are covered in
a decorative black leather substitute.
Upon request a Laser Port can be embedded
in the table top allowing a laser beam to be let
through the table (see the next page).
The Honeycomb Table Tops 1HT have been
mechanically and acoustically tested by qualified
specialists.

Phone: +370-5-2651474t

1-1

Honeycomb Table Tops 1HT provide the base on which
precision optical and laser work is performed. The table
tops have a honeycomb core inside.
The table tops meet high requirements for rigidity,
flatness, vibration isolation and damping. We work
constantly to improve the design, weight and costeffectiveness of the table tops.
Standard Honeycomb Tabletop 1HT consists of a 5 mm
thick cold-rolled stainless ferromagnetic steel top skin,
and 3-6 mm thick bottom skin, both bound under high

http://www.standa.lt

Base
Mounts &
Accessories

3

e-mail: sales@standa.ltt

–t Sandwich structure
with steel honeycomb core
–t 5 mm ferromagnetic stainless steel
top skin with a pattern of M6 holes
spaced by 25 mm
–t Surface flatness ±0.1 mm over
any 1m² area
–t Laser Port (optional – see the next page)