WM531 Remote sensor control0 pages

Remote Sensor Control

The WM-531 Shaft Hand Control is built for a range of offroad applications. The unit is designed for remote
installation and mechanical interface with a throttle position
sensor. It is infinitely variable between 0 and 54 degrees,
with applicable uses that include engine RPM and chassis
module outputs.
The Remote Sensor Control unit is equipped with a Hall
Effect non-contact sensor that can be programmed for
analog output and/or integrated switches. The electronics
are IP67 sealed and highly EMI resistant (SAE J1113). In
addition, the remote sensor control unit can be customized
with contact or PWM sensors.
The Remote Sensor Control is environmentally protected,
allowing it to be mounted inside or outside the cab. It is
made out of aluminum with stainless steel shaft.
The unit is available with two shaft designs: knurled and Dshaft.

SPECIFICATIONS
PRODUCT LIFE

Full Travel Cycles

1,000,000

ELECTRONICS

Seal Integrity
EMI

Electronics IP67 sealed (IEC 60529)
SAE J1113 Compliant

ELECTRICAL

Operating Voltage
Output Signal

5V and 12V-24V
Dual APS, Dual PWM, APS, PWM,
APS/IVS

TRAVEL ANGLE

Degrees

54°

MECHANICAL

Max Torque

71 Nm

ENVIRONMENTAL

Operating Temp Range
Storage Temp Range
Humidity
Sand/Dust

-40°C to 85°C
-40°C to 85°C
95% RH for 120 hours, 27°C to 75°C
Tested to SAE J1455

MATERIALS

Main Body
Shaft
Sensor Housing

Aluminum, 6061
Stainless steel
PBT

Industrial G