FT245R Datasheet0 pages

Document No.: FT_000052
FT245R USB FIFO IC Datasheet Version 2.12
Clearance No.: FTDI# 39

Future Technology
Devices International Ltd.
FT245R USB FIFO IC

The FT245R is a USB to parallel FIFO
interface with the following advanced
features:

Device supplied pre-programmed with unique USB
serial number.
Supports bus powered, self powered and high-power
bus powered USB configurations.

Single chip USB to parallel FIFO bidirectional
data transfer interface.

Integrated +3.3V level converter for USB I/O.

Entire USB protocol handled on the chip. No
USB specific firmware programming required.

Integrated level converter on FIFO interface for
interfacing to external logic running at between
+1.8V and +5V.

Fully integrated 1024 bit EEPROM storing
device descriptors and FIFO I/O configuration.
Fully integrated USB termination resistors.

True 5V/3.3V/2.8V/1.8V CMOS drive output and TTL
input.
Configurable I/O pin output drive strength.

Fully integrated clock generation with no
external crystal required.

Integrated power-on-reset circuit.

Data transfer rates up to 1Mbyte / second.

Fully integrated AVCC supply filtering - no external
filtering required.

128 byte receive buffer and 256 byte transmit
buffer utilising buffer smoothing technology to
allow for high data throughput.

+3.3V (using external oscillator) to +5.25V (using
internal oscillator) Single Supply Operation.

FTDI‟s royalty-free Virtual Com Port (VCP) and
Direct (D2XX) drivers eliminate the
requirement for USB driver development in
most cases.

Low operating and USB suspend current.
Low USB bandwidth consumption.
UHCI/OHCI/EHCI host controller compatible.

Unique USB FTDIChip-ID™ feature.

USB 2.0 Full Speed compatible.

Configurable FIFO interface I/O pins.

-40°C to 85°C extended operating temperature
range.

Synchronous and asynchronous bit bang
interface options.

Available in compact Pb-free 28 Pin SSOP and QFN32 packages (both RoHS compliant).

Neither the whole nor any part of the information contained in, or the product described in this manual, may be adapted or reproduced
in any material or electronic form without the prior written consent of the copyright holder. This product and its documentation are
supplied on an as-is basis and no warranty as to their suitability for any particular purpose is either made or implied. Future Technology
Devices International Ltd will not accept any claim for damages howsoever arising as a result of use or failure of this product. Your
statutory rights are not affected. This product or any variant of it is not intended for use in any medical appliance, device or system in
which the failure of the product might reasonably be expected to result in personal injury. This document provides preliminary
information that may be subject to change without notice. No freedom to use patents or other intellectual property rights is implied by
the publication of this document. Future Technology Devices International Ltd, Unit 1, 2 Seaward Place, Centurion Business Park,
Glasgow G41 1HH United Kingdom. Scotland Registered Company Number: SC136640

Copyright © 2010 Future Technology Devices International Limited

1