LDX-36000 Series0 pages

LDX
36000
Series
High Power
Laser Diode
Driver
Specifications
Product Features
GENERAL
GPIB Interface:
On-Board Memory Storage
On-Board Upload Rate
LASER DIODE PROTECTION
Output Shorting Relay:
Hardware Fault Response Time:
Current Limit:
Open Circuit:
Transient Protection:
IEEE488
1000 points
30 ms/point
Current Draw:
LDX-36010-12:
LDX-36025-12:
LDX-36050-12:
LDX-36085-12:
LDX-36125-12:
100-120VAC
+10%
4A
6A
10A
15A
20A
200-240VAC
+10%
2A
3A
5A
7.5A
10A
LDX-36010-35:
LDX-36018-35:
7A
12A
20A
N/A
N/A
Compliance voltage up to 35V
10A
13A
LDX-36125-24:
Output current to 220A QCW
and 125A CW
< 2 s
< 50 s
Output On/Off
Power Up/Down
EFT/Surge
0 to full scale
0 to full scale
2s
< 6 ms
3.5A
6A
LDX-36040-30:
LDX-36070-30:
Normally closed
16A
Size (HxWxD):23
Weight
LDX-36010-12:
LDX-36025-12:
LDX-36050-12:
LDX-36085-12:
LDX-36125-12:
LDX-36010-35:
LDX-36018-35:
LDX-36040-30:
LDX-36070-30:
LDX-36125-24:
Operating Temperature:
Storage Temperature:
Humidity:
EMC:
Safety:
Regulatory Compliance:
CE:
Connectors:
Current Output (<50A):
Current Output (>50A):
Measurement:
Interlocks:
Input/Output Trigger:
Pulse Out:
Adjustable Current Limit:
Adjustable Voltage Limit:
Output Enable Delay:
Interlock Response Time:22
Proven high power laser diode
protection features
Precision current control with
10 mA setpoint resolution
Hard pulse capability with
pulse widths to 2 seconds
and duty cycle to 90%
Peak and CW forward voltage and
photodiode measurement
146mm x 483mm x 451mm
5.25” x 19” x 17.75”
10.9 kg (24 lbs.)
11.9 kg (26 lbs.)
11.9 kg (26 lbs.)
13.5 kg (30 lbs.)
15.2 kg (34 lbs.)
11.3 kg (25 lbs.)
11.9 kg (26 lbs.)
13.5 kg (30 lbs.)
16.3 kg (36 lbs.)
18.9 kg (41 lbs.)
0°C to 40°C
-40°C to 70°C
20-85% non-condensing
98/336/EEC
21CFR 1040.10
EN60950
Low voltage directive
EN61326-1:2006
EN55011:2007
EN61010
Hybrid D-sub
Bus Bar
DB 9; rear panel
Terminal block; rear panel
BNC; front panel
BNC; rear panel
ORDERING INFORMATION
TTL trigger input and output with
adjustable delay
LDX-36010-12
LDX-36025-12
LDX-36050-12
LDX-36085-12
LDX-36125-12
10A/20A, 12V Laser Diode Current Source
25A/50A, 12V Laser Diode Current Source
50A/100A, 12V Laser Diode Current Source
85A/170A, 12V Laser Diode Current Source
125A/220A, 12V Laser Diode Current Source
Temperature measurement with
thermistor input
LDX-36010-35
LDX-36018-35
LDX-36040-30
LDX-36070-30
LDX-36125-24
10A/20A, 35V Laser Diode Current Source
18A/40A, 35V Laser Diode Current Source
40A/80A, 30V Laser Diode Current Source
70A/160A, 30V Laser Diode Current Source
125A/220A, 24V Laser Diode Current Source
LDM-4409
LDM-4415
LDM-49840
LDM-49840T
LDM-49860
LDM-49860T
LDM-4986001
Temperature Controlled C-Mount Fixture
Temperature Controlled CS Bar Mount Fixture
High Power Buttery Mount
High Power Buttery Mount with Case Control
High Power 2-Pin Module Mount
High Power 2-Pin Module Mount with Case Control
49860 Terminal Block for JDS Uniphase Devices
LDT-53520
LDT-53540
The LDX-36000 Series High Power Laser Diode Drivers
are a family of high performance current sources designed
specically for controlling and testing high power laser diodes.
Over ten models offer maximum current ranges from 10 amps to
220 amps QCW and 125 amps CW with maximum compliance
voltages from 12V to 35V. Each instrument offers high setpoint
accuracy, low output noise with forward voltage and photodiode
measurements in CW, QCW-Pulse and hard pulse operating
modes making these instruments ideal for precision, high power
laser diode testing.
Multiple laser diode protection features include adjustable
voltage and current limits, output shorting relays, slow turn on/
off circuits, fast error detection circuits, and transient protection
during power up and laser operation. A thermistor based
temperature monitor provides additional protection through a
programmable temperature limit which can be used to disable
the laser output when the limit is exceeded.
Designed for automated laser diode testing in CW or pulse
mode, these drivers combine precision control and measurement
and an IEEE488/GPIB interface with on-board data storage for
high power laser diode characterization. For virtual instrument
programming, LabView instrument drivers are available free of
charge and can be downloaded from the ILX website.
250W Laser Diode Thermoelectric Chiller
400W Laser Diode Thermoelectric Chiller
IEEE488/GPIB interface
In keeping with our commitment to continuing improvement, ILX Lightwave reserves the right to change
specications without notice or liability for such changes.
High Voltage Current Sources for
High Power Laser Diode Testing
For information call
P.O. Box 6310, Bozeman, MT 59771 • FAX: 406-586-9405
www.ilxlightwave.com
1-800-459-9459
International Inquiries: 406-556-2481
email: sales@ilxlightwave.com
Rev07.032610
LDX
36000
Series
High Power
Laser Diode
Driver