V1 Mini Vacuum Dehydrator0 pages

HY-PRO FILTRATION

1 GPM Dehydration
VUD
Hy-Pro Vacuum
Remove Free & Dissolved Water
down to 20 PPM (0.002%)
Remove Free & Dissolved Gasses
Visually Monitor Fluid and Process
through Clear Chamber Covers
High Water Removal Efficiency
High Efficiency Particulate Filtration

The VAC-U-DRY Purification Process
Contaminated oil is drawn into the VAC-U-DRY
purifier by a high output vacuum pump. The oil passes
through the low watt density heater where heated to
optimum temperature for the dehydration process
(150°F, 66°C). The oil enters the vacuum chamber
passing through specially designed dispersal elements
which create a thin film of oil that is exposed to the
vacuum. The water is vaporized and then drawn into
the condenser where it becomes liquid and drains into
the condensate tank. The dehydrated oil flows to the
bottom of the vacuum chamber and is removed by the
discharge pump. The oil is pumped through the high
efficiency particulate filter assembly (βx[c] >1000) and
returned to the system. The recirculating line helps the
VAC-U-DRY reach optimum temperature in cold start
situations and can be used to throttle machine inlet
and outlet flow.

75% of All Hydraulic Component Failures
are Caused by Fluid Contamination
The effects of moisture in your oil systems can
drastically reduce on stream plant availability. Bearing
life and critical component life is greatly reduced by
moisture levels above and within the saturation point.
Many systems run constantly above this point due to
inefficient dehydration technologies and high ingression.
This develops acidity and loss of lubrication properties.
Unit Specifications
Flow Rate

.5 ~ 1.8 GPM (1.89 ~ 6.81 LPM)

Pump Type

Dry Seal Piston Pump

Amp Draw

120 VAC - 1KW Heat (15 FLA)
220 VAC - 4.5KW Heat (23 FLA)
230 VAC - 4.5KW Heat (23 FLA)

Air Cooled
Condenser
*Flow rate is adjustable based on recirculation line flow.
The V1 is designed for reservoirs < 150 gallons @ 110-125°F.

www.hyprofiltration.com

V1