Powerflow0 pages

®

Bagela injection system Powerflow
Accessories spare and wear parts
Injection system Powerflow
Designed to blow in optical fibre cable from dia.: 8-22mm into
ducts of a dia. 32-50 mm. It is suitable for air- and water blowing.
The drive chains are propelled by two low-wear and low-noise
hydraulic motors which enable for- and backward movement of
the cable. Only a few changes are necessary to change to different
cable or pipe sizes.
max. speed:
80 m/min
required air flow:
10 m³/min
required air pressure:
12 bar
Control unit and Power Pack (125 bar / 15 L/min)
essential!
Order No. 111.200.00

Spare Parts and additional accessory
Chain rail
The chain rail, made from brass, supports the upper and lower
drive chain. It is recommended to change the top / bottom rail at
the same time.
Order No. 111.220.00
Drive chain
The drive unit constructed for cable dia. 8-22mm consists of two
superimposed conveyor chains, provided with special rubber
profile. The drive chains pull the cable from the drum into the
blowing junction block wherefrom it is inserted into the tube by
air or water pressure. It is recommended to change both drive
chains at the same time.
Order No. 111.222.00

Cable guide roller, horizontal
The horizontal and vertical cable guide rollers lead and protect the
fibre cable by the entry into the Powerflow.
Order No. 111.224.00

Cable guide roller, vertical
Order No. 111.225.00

Specifications are subject without notice. Output details are depending on use conditions

Bagela

®

7