Vacuum Pick-Up Attachment0 pages
DELTA REGIS
Tools Inc.
DRIVER BITS AND VAC PICKUP
SCREWDRIVER VACUUM PICKUP ATTACHMENT
Need to hold a non-ferrous fastener with the bit of your electric screwdriver? The Delta Regis Vacuum Pickup
Attachment is a miniature, bit-mounted vacuum nozzle. The vacuum attachment is held on the screwdriver bit
by a collet appropriately sized for the shank diameter of the bit. This allows for initial positioning of the pickup
nozzle relative to the tip of the screwdriver bit. The nozzle tip is spring loaded and has a small amount of linear
travel. The head of the screw seals up against the end of the nozzle and the nozzle rotates with the screw and
driver bit. The outer collar of the attachment remains stationary and connects to a vacuum supply.
VACUUM PICKUP ATTACHMENT WITH DRIVER BIT
The vacuum pickup attachment is ordered as an assembly complete with the required
screwdriver bit. The nozzle which seals the vacuum against the fastener rotates with
the screw head and driver bit. The table below outlines options to specify a model
number for the assembly. Please note that the bit types and nozzle configurations
shown below cover the most common applications. Please contact us for information
on other bit types or special nozzle configurations.
Material
Code
H70PH1
30
A
Aluminum
Brass
S
VACPU
A
B
Model #
Nozzle
Material
Stainless
M2
Code
Bit Type
Length
(mm)
Replacement
Bit Part #
Bit Tip Bit Shank Collet Dia
Dia (mm) Dia (mm)
Code
H70PHX
PH #00
70
DR91-1202XRD-A
2
3
30
H70PH0
PH #0
70
DR91-12020RD-A
2.5
3
30
M0
10
6.4
3.2
H70PH1
PH #1
70
DR91-12021RD-A
2.5
3
30
M1
10
6.4
4
H70PH2
PH #2
70
DR91-12022RD-A
3
4
40
M2
10
6.4
4.5
H70TX5
TX5
70
DR91-135171
3
3
30
M3
10
8
5
H70TX6
TX6
70
DR91-134740
3
3
30
M4
10
8
6.4
H70TX8
TX8
70
DR91-060098
3
3
30
H70TX10
TX10
70
DR91-060100
4
4
40
H70TX15
TX15
70
DR91-060105
4
4
40
H70TX15
TX15
70
DR91-060105
4
4
40
DR80-VACPUMP VACUUM GENERATOR ASSEMBLY
The DR80-VACPUMP acts as a vacuum source for the VACPU assembly.
The vacuum generator operates on a compressed air supply and
includes an ON/OFF slide valve and a pressure regulator to adjust the
vacuum flow. 2.5m (8 ft) of 6mm OD tubing is included to connect the
VACPUMP to the fitting on the vacuum pickup attachment.
Air Supply requirements: 1 SCFM, 45-90 psig, 1/4” npt inlet port
Page 30
sales@deltaregis.com
Nozzle
Code
Length
(mm)
OD
(mm)
ID
(mm)
‘M’ Nozzles require min. 70mm bit length
Select a nozzle with an ID at least 1mm
larger than the bit tip diameter. Nozzle ID
must be smaller than the screw head OD.