CC-KL - Filtercart0 pages
Filtercart for additional filtration of
hydraulic systems
According to the recommendations
of the manufacturers of the military
equipment with integrated hydraulic
systems, the hydraulic oil has to be
changed every 1, 2, or 3 years.
However, the need to change oil
and filters no longer depends on
what is recommended by the
manufacturers, but is depicted by
the hydraulic system itself. The
contamination level (90% of the
failures is caused by debris such as,
sand/dirt particles, wear metals and
water contaminants in the hydraulic
system) needs to be maintained at
an acceptable level to determine
whether or not the oil and system
filters need to be changed.
Savings
The most obvious cost of contaminated oil is machine downtime. The number of times you need to
replace pumps, valves etc. is directly related to the condition of the oil in the system. The total cost
of replacing oil increases as the cost of disposing contaminated oil grows. The use of a filtercart will
decrease the times needed to change the oil and as a result, lead to lower disposal costs.
TECHNICAL DATA
Types: for hydraulic fluid H-540 (NSN: 4320-17-107-1784)
for hydraulic fluid C-635 (NSN: 4320-17-105-7981 )
mineral oil according to DIN 51524/51525
Filterelements: type “Spin-on” with two parallel filters
filtration ratio â3 = 200 (lSO 4572)
max. pressure 10 bar and max. flow 600 I/min.
E-motor: 230 VAC ±10%, 50 Hz, 1 phase
other voltage and frequency optional
Pump: viscosity up to 800 cSt at -10°C
proportional flow 8 - 27 I/min.
max. suction pressure 0.7 bar
safeguarded against pumping without flow
AMCA HYDRAULIC FLUID POWER B.V.
P.O.BOX 18, 9790 AA Ten Boer Tel. +31 (0)50 3023577
B.Kuiperweg 33, 9792 PJ Ten Post Fax. +31 (0)50 3021226
The Netherlands email: sales@amca-nl.com
homepage: http://www.amca-nl.com
AMCA-FILTERCART Series CC-KL
AMCA Hydraulic Fluid Power BV