CHIP SCREENS0 pages

CHIP SCREENS
O P T I ONS 5’ x 10’ CHIP SCREEN

•t Set of four legs, 41” long for raising screen to discharge into 30 HP or 40 HP blower.
•t Cyclone support frame.

O P T I ONS 7’ x 14’ CHIP SCREEN

•t Set of four legs, 41” long for raising screen to discharge into conveyor.
•t Cyclone support frame.

S P E C I F I C AT I O N S
G E N E R AL

5’ x 10’ CHIP SCREEN
HP................................................................................ 10 @ 1800
Screen RPM........................................................................... 300
Surface (sq. ft).........................................................................50
Capacity....................................................................................25
7’ x 14’ CHIP SCREEN
HP................................................................................ 15 @ 1800
Screen RPM........................................................................... 300
Surface (sq. ft).........................................................................95
Capacity (tons/hr)..................................................................50
10’ x 20’ CHIP SCREEN
HP................................................................................ 20 @ 1800
Screen RPM........................................................................... 300
Surface (sq. ft.)..................................................................169.2
Capacity ................................................................................ 160

Note: Specifications may vary with equipment options

STANDARD EQUIPMENT
5’ x 10’ CHIP SCREEN

5’ x 10’ two deck high-speed chip screen. Suspension frame is constructed from 6” x 6” wall tubing
with 3” steel tube U-joints
Screen frame is constructed from 6” x 6” and 8” x 4”
wall tubing with 10 gauge side plates
10 HP electric drive with dual bearings (Timkin)
mounted in a common housing
Counterweight shaft is 6” diameter and runs @ 300
RPM
Top screen plate (specify size of opening ad
whether it’s to be square or round holes)
Bottom screen plate (specify size of opening and
whether it’s to be square or round holes)
Specify direction of fines discharge (right or left)
Directions of accepts discharge is to center (specify
full front discharge or funneled down to 25” for
discharging into blower)

7’ x 14’ CHIP SCREEN

7’ x 14’ two deck high-speed chip screen. Suspension
frame is constructed from 6” x 6” x 1/2” wall tubing
with 3” steel tube U-joints
Screen frame is constructed from 6” x 6” x 3/8” and 8”
x 4” x 3/8” wall tubing with 10 gauge side plates
15 HP electric drive with duel bearings (Timkin)
mounted in a common housing
Counterweight shaft is 6” diameter and runs @ 300
RPM
Top screen plate (specify size of opening and whether
it is to be square or rounded holes)
Bottom screen plate (specify size of opening and
whether it is to be square or rounded holes)
Specify direction of fines discharge (right or left)
Specify direction of overs discharge (right or left)
Direction of accepts discharge is to center (full front
discharge)

03052010