2355 Flail Chiparvestor0 pages

GENERAL
Length .................................................................................54’3”
Height ..................................................................................13’8’’
Width..................................................................................12’10”
Gross weight ........................................................115,200 lb.
Horsepower.....................................................up to 1,050 HP
Engine............................................................CAT or Cummins
Tri-axle trailer....................................75,000 lb. suspension
Drive (flail)..................................................................hydraulic
Drive (chipper).....................................................................belt
Fuel capacity.........................................................500 gallons
Hydraulic oil capacity (flail)..............................200 gallons
Hydraulic oil capacity (feed system & loader)
...................................................................................300 gallons
CAB AND LOADER
Cab offers operator a deluxe 6-way adjustable seat, joy stick controls, combination air conditioner/heater, and emergency shut-down system. Along with, complete engine gauge panel for both power units located in cab
Hydraulic tilt-down cab for transport
Morbark 500 knuckleboom loader, 23’ reach, 270º swing and 360º continuous rotation grapple
Lift capacity of 17,200 lb. at 10’
FLAIL
Infeed opening 23” x 55”
Three top feed rollers mounted on yoke assemblies
Five stationary bottom feed rollers
MORBARK Model 2355 Flail Chiparvestor
OPTIONS
• Three or four knife chipper disc
• Third flail drum
• Discharge spout extension
• ESPAR heating system for cold weather start
• Dual engines
• Reversing fan
• 11-HP air compressor
• Electric power option
• Halogen light package
• Remote control
• Discharge spout extension to load open top vans or rail cars
SPECIFICATIONS
HYDROSTATIC CONTROLS
Flail drive is a closed loop hydraulic design with separate hydraulic systems to operate each flail drum. Each system is complete with electric tach and controls in operator’s cab.
CHIPPER DISC
Each disc is fabricated from plate steel and
put through ultrasonic testing. Material
certification is issued for each disc, which
provides the best chipper disc in the industry.
SPREADER INFEED
This unique infeed system spreads multiple stems apart, which assists with more complete bark removal.
CHIP QUALITY
Units produce quality chips even in non-merchantable and juvenile timber.
Dual horizontal chain flails with patented segmented drums are equipped with eight flail chain rods
Discharge system consisting of 60-1/2” wide x 23’ long telescoping drag chain conveyor with hydraulic drive
Air curtain
CHIPPER
23” diameter chipping capacity
75” diameter chipper disc with three or four knife configuration
Built-in dirt separator, debris is bottom discharged into dual 12” diameter twig augers which discharge directly into the 23’ refuse drag chain
Hydraulic swivel/telescoping discharge spout
Note: Specifications may vary with equipment options 02252010