ASC 45210 pages
www.asc-sensors.de
MEMS Capacitive Accelerometer
ASC 4521 / ASC 4525
Uniaxial
4 Wire System
Amplified Output
Aluminium Housing /
Stainless Steel Housing
Made in Germany
Features
Range: ±1g to ±200g
DC Response
Gas Damped
Excellent Bias and
Scale Factor Stability
Low Power Consumption
Single Ended Mode
Capacitive MEMS Technology
The accelerometers are based on a capacitive MEMS technology and can be used in a low
frequency response up from 0Hz. Inside the sensor element, the seismic mass is connected
with two conductive capacitor plates. If the seismic mass oscillates between the two capacitor
plates the capacitance will change. This capacitance change is converted via an ASIC
(Application Specific Integrated Circuit) into an analog signal.
Description
Options
Customised Cable Length
Customised Connector
TEDS Module
Applications
Structural Monitoring and
Testing
Endurance Testing
Brake Test
Vibration Monitoring
Civil Engineering
Modal Analysis
Vehicle Testing
Automotive Ride Quality
& Comfort
Railway Engineering
Flutter Test
The models ASC 4521 and ASC 4525 have been developed for the demanding requirements of
different applications. The highly robust housing and the connecting cables are suitable for
the rough application areas in automotive, train, military and so on.
These ASC accelerometers benefit from the high stability of the chip technology with a low
bias and an excellent scale factor temperature coefficient.
The ASC 4521 and ASC 4525 are fully compensated over a wide temperature range and are
factory calibrated. As capacitive technology is used, extremely small measuring ranges are
possible. The amplified output is easy to use with a data acquisition unit. The signal is
independent from the power between +8VDC to +30VDC.
A very high flexible and rugged cable provides a simple mounting. The ASC 4521 and ASC 4525
are equipped with 2 meter cable as standard.
ASC GmbH · Advanced Sensors Calibration · Schäfflerstraße 15 · 85276 Pfaffenhofen · Germany
"