SWAM-BLAST® All0 pages

The SWAM-BLASTER® line of Micro Abrasive
Blasters are complete, accurate and precise.
With independently adjustable
®
powder flow control and air
pressure regulation, Total Process
Control can be achieved.
The SWAM BLASTERs introduce a defined amount of abrasive powder into a
controlled stream of compressed air through the abrasive pathway and out of a
selected nozzle tip. When detail is required, the powder flow can be turned
down to reduce the amount of powder being introduced into the abrasive
pathway thus, allowing the use of a very small nozzle tip. For more aggressive
requirements, the air pressure, powder flow and the nozzle tip diameter can be
increased.
The basic design of the Model EV-2 Micro Abrasive Blaster and the
Model EV-2L is an “Economical Version” for
the moderate applications with brass fittings
throughout the abrasive pathway. The Model
EV-2 has a nozzle range from .007” up to .040”
and for more aggressive applications that
require a larger nozzle range, the Model EV-2L
is suitable from .018” up to .060”.
The unique design of the Model MV-2 Micro Abrasive Blaster and the
Model MV-2L offers “Maximum Versatility” with
carbide lined fittings throughout the abrasive
pathway and with the tilting powder tank that is
mounted to a hinged plate to allow it to tilt to
the side and with the push of a button, the
vibrator activates to simply walk the powder out
for rapid powder changes.
The optimum nozzle range for the Model MV-2 is from .007” up to .040”
and the Model MV-2L is from .018” up to .060” for the more aggressive
applications.

The Model MV-241 Micro Abrasive Blaster is the ultimate in “Maximum
Versatility”. This model is a combination of
the precise ability of the Model MV-2 and the
aggressive attitude of the Model MV-2L in
one unit. Just press the toggle switch on the
front panel to green to use nozzles from .011”
up to .032” or press the switch to amber to
use nozzles from .018” up to .060”.
The Model LV-1 (Large Volume) Micro Abrasive Blaster is best for
operating in production lines and in the SWAM® Automated Systems. The
Model LV-1 features an hour meter for SPC monitoring and a leak detection
system for the pinch valve assemblies. It holds approximately 20 pounds of
aluminum oxide and has a separate mixing powder tank for a consistent
powder feed rate from a full tank to an empty tank.
For applications where the Model LV-1 is not quite
enough, the Model XV-1 (Xstream™ Volume)
Micro Abrasive Blaster is the solution for the
heaviest output requirements. Similar to the LV-1, it
is equipped with larger hoses and fittings throughout
the abrasive/air pathway.
The Model LV-1 works very well with a nozzle range
from .018” up to .060”. For the Model XV-1, the
optimum nozzle range is .032” up to .090”.

CRYSTAL MARK, INC.
A SWAN TECHNOLOGIES CORPORATION

613 Justin Avenue
Glendale, CA 91201

(800)659-7926 • (818)240-7520 • Fax (818)247-3574

http://www.crystalmarkinc.com
sales@crystalmarkinc.com
©2007 Crystal Mark, Inc. All rights reserved. 10/30/09

SWAM BLAST ALL.DOC