Servo Power Supply SPS-600-1260 pages

Servo Power Supply SPS-600-126

1. Liability conditions
The responsible staff must ensure that the application or use of the products described satisfy all the requirements for
safety, including all the relevant laws, regulations, guidelines and standards.
The documentation has been prepared with care. This product and documentation are constantly under development.
For this reason, the documentation may not always be have been fully checked for consistency with the performance
data, standards or other characteristics described. In the event that it contains technical or editorial errors, we retain
the right to make alterations at any time and without warning. No claims for the modification of products that have
already been supplied may be made on the basis of the data, diagrams and descriptions in this documentation.

Warning! This product has unshielded live 115/230V AC mains parts posing
electric shock hazard. Never touch any part of this product when AC power is
connected!
Always consult experienced electrician for checking power supply installation safety.
Before installing or using SPS product, make sure you have read and understood completely
this document and third party document referenced in the chapter 4.
Granite Devices or its personnel will not carry any consequences or give any warranty if
safety aspects are overlooked.

2. Introduction
SPS series power supplies are optimized for high peak power loads
which ideally match typical position control servo/stepper
applications. SPS is capable of delivering up to 3x peak power
compared to average output power level without overheating or
causing significant voltage drop.
SPS reduces cost and increases efficiency and reliability by skipping
voltage regulation which is unnecessary for VSD motor drives.
In addition to this document, user must read also documentation
referenced in chapter 4.

Key specifications
•

Input voltage 115 or 230 VAC

•

Nominal output voltage 126 VDC ± 10%

•

Peak output power 650W @ 230VAC input

•

Continuous power 210W without active cooling

•

Can be paralleled to increase output power

•

Small form factor & lightweight

•

Low EMI

Applications
•

Power for servo and stepper motors

•

Position controlled machines

•

Up to 300W continuous rated motor per SPS

•

Ideal PSU for BL70-300 servo motor