"
1300 V-MILL
I N F E E D OPTIONS
•t
t
t
t
Infeed chute attaches to impact hopper and directs material to hammermill rotor.
Chute is constructed from 1/4” thick sides and 1/2” thick top and back. Standard
chute opening for infeed conveyor is 50 1/2” wide and 43 15/16” high and includes a
double debris curtain for material containment. Must specify infeed material size.
OUTFEED OPTIONS
•t Discharge chute back and sides are constructed from 1/4” thick T1 steel. Rubber
t seals around bottom of chute help contain material flow on to optional outfeed
t conveyor. (specify direction of discharge).
•t
t
t
t
Outfeed Trough Type Belt Discharge Conveyor, 60” wide x 22’ long, complete with
three (3) troughing rolls and three (3) idler rolls. Head and tail pulley (self-cleaning)
are 12” diameter with 2-7/16” shafts. 5-HP electric drive with gear reduction drive.
Conveyor mounts underneath Hammermill.
•t Longer or shorter outfeed belt conveyor per foot.
•t 2,000 Series Char-Lynn Hydraulic Drive in lieu of standard for the discharge
t conveyor (less power source).
•t Magnetized End Pulley, for discharge conveyor, complete with collecting
t slide tray for ferrous metal removal.
S P E C I F I C A T I O N S Note: Specifications may vary with equipment options
G E N E R AL
Power.................................................................Up to 1000 HP
Hammers...............................................Twenty-four 2” thick
T-1 steel fixed hammers with
double-edged, replaceable teeth inserts
Screens............................ 1” thick wear form steel screens
Length...................................................................................... 20’
Hammermill opening.............................................. 31” x 55”
Rotor dimensions................................... 20” diameter with
eight 2-1/4” hammer retaining rods
mounted on a 7” diameter rotor shaft
STANDARD EQUIPMENT
31” x 55” hammermill system constructed of heavy
duty 20” diameter rotor, (13) 1-7/8” (2 piece) thick
laser-cut rotor plates to ensure precision and enforce
steel strength. The plates are keyed on a 7” diameter
shaft with 4-7/16” bearings and (8) 2-1/4” hammer
retaining rods. Complete with (24) 2” balanced steel
fixed teeth insert hammers and (24) 2-1/2” wide
double-edged replaceable teeth inserts.
One set of two (2), 5” hexagon x 1” thick wear form
steel heavy duty grates
Hammermill base with grate supports.
Impact hopper is constructed of 1/2” steel. Hopper
has AR plate bolt on wear plates. Hopper is hinged
for easy access to Hammermill and grates. Two
hydraulic cylinders with safety lockouts operate
Hopper tilt.
110-volt power pack to open hopper is furnished when no
hydraulic pump stand is ordered.
The frame supporting the hammermill is made of 12” x 8”
structural tubing and is 8’7” wide and 17’6” long [14’ 9” on
single engine frame]. Surface is covered with floor grating.
Motor rails
OPTIONS
Leg Package includes (6) legs, (2) sets of stairs, 3’ wide catwalk on both sides of platform and handrails. Catwalks and
handrails removed for transporting. With catwalks attached,
overall size of platform is 14’7” wide x 17’6” long. Standard
legs give platform an overall height of 84” high
Longer legs
03052010
"
عضویت 
ورود اعضا
راهنمای خرید
