ST 8600 pages

stir before use

equipment with

sikkens

WOOD COATINGS

ST 860

Product description

Colour

Packaging

Processing

Thinning

Application temperature

Drying times

Cleaning of equipment

Storage

Disposal

Hazard identification

Warning

VOC guideline

General instructions

Coating recommendation

Fluid additive to produce a brush applyable paint/varnish from waterborne sprayable products.

Use solely for Spot Repair.

- neutral odour

- easy to apply

Colorless

1L

The additive must be added to a sprayable product in a ration of 1 part of ST 860 : 10 parts of varnish/translucent finish.

Carefully stir the mixture. Application by brush.

Mixing ratio: 1:10

Do not thin down

15 - 25 °C for substrate, air and material at approx. 60 % R.H.

The drying process of the coating depends on the applied wet film thickness and can extend when using timber with a

high extract contents or drying in damp/cold conditions. During the drying process one should ensure for adequate

temperature and ventilation.

If the drying conditions are not upheld, damages within the coating cannot be warranted.

Clean directly after use with water, if needed with washing up liquid or with ST 830.

The minimum storage stability of sealed containers is 2 years.

Storage temperature: +5 - +30 °C.

After ending of the storage time the product still can be usable, but some attributes may vary from new product.

Therefore such over-stored product has to be applied with special attention.

Opened cans must be sealed correctly! Store in a cool but frost-protected area.

Only residue emptied cans can be disposed via recycling. Liquid wastes must be disposed of according to national

regulations or according to EU-disposal key 08 01 12.

In accordance with EC guide lines - Material safety data sheet, point 15.

Before use, read the identification and product information. Even when working with low emission products one should

take care of the customary protection measures.

Out of scope.

For use in technical industrial companies and intended only for recommended Sikkens systems.

Achievable layer thicknesses:

1 x brushing = 25 um dry layer

2 x brushing = 45 um dry layer

3 x brushing = 60 um dry layer

All details on our products contained in this publication do not represent details of the quality of the goods. The quality, suitability, qualification and function intended use of

our goods shall be determined exclusively in accordance with the product descriptions based on the respective sales agreements. In each case, deviations typical of the sector

shall be admissible, unless agreed in writing otherwise. All details correspond to todays state of technology. We make no claim as to the completness of the stated coating

installations; they are stated merely as possible examples. Due to the large number of substrates and object conditions, the buyer/user shall not be released from his/her

obligation to check our raw materials in a workmanlike manner for their suitability for the intended purpose on his/her own responsibility subject to the respective property

conditions and process these in accordance with the respective state of technology. In other respects, our standard terms and conditions of sale apply. Upon the appearance

of a new edition, this publication shall lose it's validity.

Akzo Nobel Industrial Coatings Ltd Unit 4a, Mercer Way, Shadsworth Blackburn, Lanes, BB12QZ

Bus Pk

Akzo Nobel Industrial Coatings Ltd Unit 4a, Mercer Way, Shadsworth Blackburn, Lanes, BB12QZ

Bus Pk

Akzo Nobel Wood Coatings GmbH Diisseldorfer StraGe 96-100 40721 Hilden

AkzoNobel

United Kingdom Tel. +44 1254 687950 Fax. +44 1254 687960

Rep of Ireland Tel. +35 (0) 21 4220222 Fax. +35 (0) 21 4220205

Germany Tel.: +49-2103-77-800 Fax: +49-2103-77-577