Series 607 Specs0 pages

Series 607

360° Precision Feedback and Display
The Model 0607-0001 Optical Encoder and Model 10040000 Counter Display system provides precision feedback
and readout of shaft angular displacement over the full
360° revolution. From a fixed or user settable point, angular
position is displayed in degrees over indefinite shaft
revolutions at speeds up to 3000 RPM, with equivalent BCD
output. In simplest mode, Encoder position is displayed
in increments of 0.05° over the range 0.00° to 359.95°.
Display and Encoder are sold separately and will deliver full
accuracy without adjustment.

KEY FEATURES
Displays Full 360° Working Range

0.05° Accuracy and 0.05° Resolution

Speeds to 3,000 RPM

Binary-Coded-Decimal (BCD) Output

MODEL 0607-0001 OPTICAL ENCODER

MODEL 1004-0000 COUNTER DISPLAY

Model 0607-0001 is a rotary, incremental Encoder that outputs
1800 cycles of quadrature TTL signal and one zero reference
plus (Zr) per shaft revolution. Compact size, low weight, and
servo and/or bolt-face mounting make it easy to install, even
where space is limited.

Model 1004-0000 is a panel mount, 5-digit LED Display that
excited the Encoder, decodes its output into 7200 counts/
revolution, and displays the shaft angle position-in increments
of 0.05°-from the last reset. It also provides latchable, parallel
BCD output that matches the displayed value. When tri-state
enabled, the BCD output can be used as an 8-bit parallel, word
serial, multiplexed signal for input into an 8-bit port.

The Encoder’s precision pilot diameter provides a reference for
mounting the unit concentric to the shaft to be monitored. Four
tapped holes in the face, or the servo slot on its circumference,
provide two means for securing the body to the user’s
reference surface. Installation of a flexible shaft coupling is
highly recommended to protect the Encoder from excessive
misalignment or motion of the monitored shaft. Encoder cable
can be soldered directly to the Display connector or can be
extended.

The compact 1/8 DIN case, rear-panel set-up and solder
termination make it easy to install, even where space is
limited. The Display installs directly through panels up to 0.20
inch (5.1 mm) thick, or can be used as a benchtop instrument.
All necessary mating edge-type connectors are included, to
which Encoder leads, 5 VDC power and any other required
connections can be soldered directly.
The base unit is available as Model 1004-00000. Unit with
analog output options, providing +/-5.0 VDC over the range
+/-359.95°, is available as Model 1004-00001.

Tel: 800-828-3964 | Fax: 860-872-4211 | Web: www.transtekinc.com