عضویت 
ورود اعضا
راهنمای خرید
HAND HELD0 pages
HAND HELD
MEASURING DEVICE
Our hand held measuring units were developed for manual measurement of analogue sensors with either a current output
(CP/C) or an input voltage (CP/V) to
measure (CP/P) potentiometer, strain
gauges (CP/R) and Pt 100 type temperature gauges (CP/Pt).
The unit is equipped with a large 3½ digit
LCD display for easy reading in any light
condition.
The unit is powered by internal Ni-Cd rechargeable batteries, allowing several
hours of non-stop operating time. A 220
Vac feeder is supplied with the unit.
The unit is designed to be easily operated
using only one hand.
The unit can be pre-configured to your exact
needs whether physical or electrical units depending on what is being measured.
Once programmed the units of measurement cannot be changed except at our
laboratories.
The measurement can be done in different
ways:
The reading unit is switched on by an onoff button; by releasing the button the unit
switches off.
The need to hold down the switch when
the unit is on prevents accidental discharge of the battery by leaving the unit
on.
READING UNITS
1. By
the temporary connection of a
gauge to the unit. This type of reading is
done when the sensor is first put into
place within the installation and before
the sensor is set up into any automatic
system.
2. By means of a centralised control box
connected to the sensors via special
cables (supplied as standard) using waterproof connections.
