Operation manual C0 pages
‡@ Open the transparent cap on the top of the unit and depress the power button in green color.
Then, Red LED lamp continuously twinkle in “1” mode which is the initial mode.
‡A You can easily select the desirable mode because the mode can be selected in sequence just by pressing the red button.
‡B Mode selecting will be finished if the LED lamp twinkles once long after the Red LED lamp
twinkle 5 times as soon as selecting the desirable mode.
‡C If mode selecting is finished, Red LED lamp will twinkle in 10 seconds cycle, which means the unit is generating gas.
‡D After finishing mode selecting, make sure that the transparent cap should be locked in its position.
Note: The periodic checkup is necessary when lubrication points are located outside or expected
to be infiltrated by water, moisture & humidity.
‡E In case re-installment is required, make sure that contaminants around lubrication points & connections should be cleaned.
‡F The transparent body of unit can enable users to check easily the status of grease dispensing.
Note: Dispensing rate may vary according to the grease types, the ambient temperature & conditions of lubrication points.
Grease Lubricator Operation Manual
Operating Principles
pecifications
Installation Instructions
C
Pulsarlube C (KLT200C)
Pulsarlube C, New Generation of Electrochemical, Automatic SPL, is designed to ensure a precise, predictable,
and fresh supply of lubricant in a wide variety of industrial applications. Pulsarlube C delivers self- contained
(pre - packed) lubricant, under pressure, by means of a controlled electrochemical reaction that generates inert
nitrogen (N2) gas. Unlike traditional gas charged lubricators using combustible Hydrogen (H2) gas generation as
the result of metal/acid reaction, Pulsarlube C uses inert Nitrogen gas generation controlled by Microprocessor.
Doc No : 3203 Rev . 020610
5 6 7 8
1 2 3 4
Do not tamper
with product.
Purge the lube point with a grease
gun to ensure a clear passage.
Remove the grease nipple and
double check for any hardened
grease in bearing zerk.
Install the Pulsarlube C lubricator
on the lube point by screwing
in clockwise.
Press green button to turn on
dispenser and set dispensing
rate by pressing red button.
Note grease type, installation date,
expiration date, etc on the label
for your records.
Turn lubricator off at the end of
dispensing cycle by pressing
top green button..
Dispose of empty lubricator in
compliance with local waste
disposal regulations.
Grease Capacity 125, 250cc
Normal operating pressure 5.0 kgf/ (70 psi)
Operating temp range
Outlet thread size 3.8” PT (NPT Available)
Product dimensions
125cc : Ø 97 x 133mm (H)
250cc : Ø 97 x 150mm (H)
Water Proof
NLGI Range
Can be used under water.
NLGI 1, 2
Remote installation Can be remotely installed up to Max 1.0m(3ft ) using
a 8mm(1/4") tube
Specifications Description Image
1 Month
1 3 6 12
3 Month
1 3 6 12
6 Month
1 3 6 12
12 Month
1 3 6 12
1 Month
1 3 6 12