Lumiglas Luminaire Lumistar0 pages
lumiglas
Lumiglas Luminaire Series Lumistar Data Sheet 06.01
0158
lumiglas®
• for use on circular sightglass fittings
For the combination of sightglass and lightglass-suitable for circular
sightglass fittings to DIN 28120 and similar, DN 50 to DN 200.
• Application:
For illumination of internals of pressure vessels, tanks, bunkers,
silos, stirred vessels and other normally enclosed containers in
non explosion hazardous areas.
Suitable for use in food processings.
• Protection:
When correctly fitted, dust and water jet tight to IP 65 and
EN 60 529/DIN VDE 0470 part 1
• Operating Conditions:
Independent of internal vessel pressure/vacuum;
max. permissible ambient temperature measured at cable entry
gland 80° C. Where ambient temp. > 40° C, heat resistant cable
(e.g. type Sinotherm 110 H05GG-F 3G 1,5 mm2) must be fitted.
• Electrical data:
Power supply: 24 V
Lamp: 2-pin Halogen filament lamp
Power: depending on size of unit, 20 W, 50 W or 100 W
• Lamp holder: 2-pin socket
• Transformers: Can be supplied as special accessory
• Integral switch for brief ON mode:
Not maintained push button switch fitted as standard
• Mechanical installation:
- Before commencing installation please read information sheet
‘Important guidelines for mounting sightglass fittings…‘.
- The luminaire is attached to the cover flange of the circular
sightglass unit by two or four bolts. A ring gasket with bridge
provides the seal between luminaire and sightglass disc.
- The fixing bolts (zinc coated steel 8.8) are part of the supply.
- Against additional cost, the Lumistar luminaire can be supplied
complete with connecting cable.
• Electrical connection:
- Select connecting cable to suit operating conditions
- Cable diameter to suit cable entry gland (M16 x 1,5)
- Remove reflector
- Bare cable core ends
- Pass cable through gland into lamp chamber and connect to
terminals (max. 2,5 mm2)
- Tighten cable entry gland
- Fit separately packed lamp using protective cloth
- Replace reflector
• Lamp exchange:
- Caution: check luminaire temperature before commencing
- Ensure power to luminaire switched off
- Remove luminaire from cover flange
- Remove reflector and pull out lamp
- Fit new lamp by holding it with protective cloth and carefully
locating into 2-pin socket and push home
- Replace reflector, checking for cleanliness
- Check condition of bridge gasket and replace if necessary
- Set luminaire on cover flange and bolt tight
- Switch power on
Sight- and lightglass are combined
(1) Lumiglas luminaire series Lumistar, with fixing screws.
(2) Sightglass fitting DIN 28120 welded into vessel wall.
2
1
A complete unit, as supplied, of the Lumistar series
F.H.Papenmeier GmbH & Co. KG · division Lumiglas
Talweg 2 · 58239 Schwerte · GERMANY
phone: +49-2304/2050 · fax: +49-2304/205206
e-mail: info.lumi@papenmeier.de
www.lumiglas.de