MG 3 T.L.0 pages

AUSONIA SRL
Via Piroleri 23/B 31030 – ALTIVOLE (TV) Italia
Tel. 0423 755303 - Fax 0423 759126
E mail:info@ausoniasrl.it
www.ausoniasrl.it
 Partita iva 03315980262
iscr.reg. impr. TV 312041-1997

Product MG 3 T.L.
Vertical hydraulic model MG3 T.L. compacting machine for compacting drums and various types of
containers, both metallic and plastic, especially used for turning paint, oil and chemical drums into
so-called pizzas.
The MG 3 T.L. compacting machine features a fully-closed compacting chamber and is loaded though
a front door. The electrical panel is located on the side with built-in command buttons.
The compacting cycle (up and down phases of the compactor) may be either automatic
button-operated or semi-automatic lever operated.
Manual removal of crushed pizzas.
The compacting machine is fitted with channels and gutters to collect any liquids that may be left in
the drums or filters to then channel them into the supplied tank.
The door is safe and simple to close thanks to its guide-system.
The compacting machine can be positioned against a wall or in a corner.
The compacting machine is made be fastened to the ground.
The compacting machine is epoxy varnished. The standard compacting machine colour is RAL 7016
grey , moving parts and protections are RAL 1007 yellow. The colours can be changed according to
the RAL table .
The compacting machine is tested at the Ausonia works prior to being shipped. The MG3 T.L. is
shipped vertically, fully loaded with oil and with circuit bled. Upon receiving the unit just replace
the non-bleeder cap with the supplied bleeder cap, check the direction of rotation of the electric
motor (only in the 380V versions) and the machine is ready for use. The usage and maintenance
manual delivered with the compacting machine, and which must be read by operators prior to use,
explains every detail for every operation and the use of the machine.
-

Roof cover for outdoor positioning.
Atex directive-compliant electric panel and remote control-unit.
Dust suction and collecting hoods in loading chamber.
Pre-varnish galvanisation to protect from any aggressive substances.
Available in the 5T version with guided plate.

AUSONIA SRL - Via Piroleri 23/B 31030 – ALTIVOLE (TV) Italia - Tel. 0423 755303 - Fax 0423 759126
E mail:info@ausoniasrl.it - www.ausoniasrl.it - Partita iva 03315980262 - iscr.reg. impr. TV 312041-1997