Product MG5 T.M.V.0 pages
PRESSE PER IMBALLAGGIO | AUSONIA SRL Via Balegante, 25 31039- RIESE PIOX° (TV) Italia Tel. 0423 755303 - Fax 0423 759126 E mail:info@ausoniasrl.it www.ausoniasrl.it Partita iva 03315980262 iscr.reg. impr. TV 312041-1997 Product MG5 T.M.V. Vertical multi-chamber, hydraulic press for compacting and shaping bales or recyclable materials such as: cardboard paper, nylon plastic, big-bags, fibre-glass and insulation in general, expanded and soft polyurethane, sponge foam, tetrapak bottles, leathers, rags, cloths, generic trash, etc.. The model MG5 T.M.V. press consists of two or more tub-chambers over which run two rails for the compactor car. The control panel and command button-panel, the pusher cylinder and control unit are inside the cart, and everything is protected by a specific carter. Material is top-loaded by moving the pusher cart from one chamber to the next. The four roller wheels and endpoint stoppers fitted on the dolly cart make moving operations simple and safe. The materials holding systems help maintain the high zone of the pan always empty at the end of each pressing cycle. - Liquid containment and collection drip pan. - Roof cover for outdoor positioning. - ATEX directive-compliant electric panel and remote control-unit. - Cage-type holding system for particular materials - Blocks for excluding the holding systems of crushed materials. - Dust suction and collecting hoods in loading chamber. - Additional chambers. - Opening the door-fitted chamber The compacting cycle (up and down compactor phases) is button-operated automatic Preset bale tying, with doors closed via door slots. Manually tied, with polypropylene banding (2 spools are supplied). Thanks to the slots on the back of the chamber, steel wire or bands can be used to bind. The bales are ejected via tipping of the front door. A specific rocking bracket exploits the up-stroke of the pressing plate to release the bale and then conveniently tipping it with a telescopic handle. Locking the bale-ejection door is done thanks to the same bracket used for locking. A special dolly cart is supplied to later move the bale. The press can be positioned against a wall. It only needs front space for material to be loaded and to expell the bales. The press is made be fastened to the ground. It can also be installed outdoors, provided the control unit assembly and control panel are protected. The press is epoxy varnished. The standard press colour is RAL 7016 grey , moving parts and protections are RAL 1007 yellow. The colours of the press can be changed according on the RAL table. The press is tested at the Ausonia works prior to being shipped. The MG5 T.M.V. is shipped vertically, fully loaded with oil and with circuit bled. On delivery just check the direction of rotation of the electric motor and the machine is ready for use. The usage and maintenance manual delivered with the press, and which must be read by operators prior to use, explains every detail for every operation and the use of the machine. AUSONIA SRL - Via Balegante, 25 31039- RIESE PIOX° (TV) Italia - Tel. 0423 755303 - Fax 0423 759126 E mail:info@ausoniasrl.it - www.ausoniasrl.it - Partita iva 03315980262 - iscr.reg. impr. TV 312041-1997
"