Power Units - GT180 pages
GT18 4-2004
SPECIFICATIONS
Stanley Hydraulic Tools
3810 S.E. Naef Road
Milwaukie, Oregon 97267
Tel 503•659•5660
Fax 503•652•1780
Visit our website at www.stanley-hydraulic-tools.com
Power Units
Features and Benefits
The new generation Stanley GT18 Power Unit is the latest in construction
site hydraulic power for tools. The GT18 conforms to the Hydraulic Tools Manufacturers Association (HTMA) Type 1 and Type 2 tool circuit recommended
performance. It will deliver 5 gpm or 8 gpm at pressures up to 2000 psi with heat rejection capacity exceeding the HTMA recommendation of 5 hp.
Significant features of the GT18 are:
• Computerized, electronic throttle control is standard on all models. The control allows for selection of constant engine speed or automatic
speed. Automatic speed increases engine speed from idle when it senses tool working demand. When there is no tool working demand, engine speed
GT18is returned to idle. The automatic speed mode provides lower fuel use and less noise.
• All electric control system with rotary switches.
• All components in the GT18 are assembled for easy routine servicing.
The upper frame can be removed for more serious servicing.
• A quartz hourmeter in the control panel records engine run time.
• The hydraulic pump is mounted directly to the engine eliminating any misalignment and ensuring long life of the drive coupling.
• An in-tank hydraulic filter continuously
cleans the hydraulic fluid and assures that refill fluid passes through the filter for a clean refill.
• A 35-Ah sealed, non-spillable, no-maintenance battery is located inside a covered compartment.
• Moving the GT18 around is made easy with a lift-and-latch handle.
• Both engine models (Briggs or Honda) have pressure lubrication systems with a pressure sensing switch that will shut down the engine
if the engine oil level is too low.
• Some GT18 models are available with 110 vac, 60 Hz electric power provided by a Briggs & Stratton PowerLink inverter system. This system will deliver 1000 watts, continuous and 1500 watts intermittent
power through GFCI receptacles.
ITEM U.S.A. METRIC
OUTPUT CAPACITY 5 or 8 gpm 20 or 30 lpm
PRESSURE 2000 psi 140 bar
CIRCUIT TYPE Open Center
HYDRAULIC RESERVOIR CAPACITY 3 gallons 11 liters
FUEL TANK CAPACITY 7 gallons 26.5 liters
WEIGHT (WET) 330 lbs 150 kg
LENGTH 35 in. 89 cm
WIDTH 21/5 in. 54.6 cm
HEIGHT 29 in. 73.7 cm
ENGINES Briggs & Stratton 18 hp Vanguard
Honda 20 hp OHV