Lumiglas Luminaire SLM0 pages
lumiglas
Data Sheet 06.02.01
EN ISO 9001
Q A: 041003296
Lumiglas Luminaire Series SLM
– high quality cast aluminium alloy version –
(for stainless steel version see data sheets 06.02.02)
• for use coupled with with screwed sightglass fittings
For the combination of sight and light port, suited to circular
screwed sightglass fittings to DIN 11851 or similar, DN 65 to
DN 125
• Application:
For the internal illumination of bio-reactors, laboratory mixers,
filters, as well as internals of pressure vessels, storage tanks,
stirred vessels, pipelines and other normally enclosed systems
in non explosion hazardous areas. Particularly suitable for
pharmaceutical and food processing industries, e.g. breweries,
dairies etc.
• Protection:
When correctly fitted, dust and water jet proof to
IP 65 and EN 60 529 / DIN VDE 0470 part 1
•Operating conditions:
Independent of internal vessel pressure/vacuum; max. permissible
ambient temperature measured at cable entry gland, 80° C.
When ambient temp. > 40° C heat resistant cable e. g.
Sinotherm 110 H05GG-F 3G 1.5 mm2 must be used.
• Electrical data:
Power supply 24 V (12 V is optionally available)
Lamp 2 pin Halogen filament lamp
depending on model, 20 W, 50 W or 100 W
• Lamp holder: 2 pin socket
• Transformers: can be supplied as special accessory
• Integral switch:
the luminaires are all fitted with integral push button switch as
standard
• Mechanical installation:
- remove slotted cover nut from sightglass unit
- pass cover nut over luminaire body
- check that glass disc correctly seated in fitting
- place cover nut with luminaire over weld nozzle and tighten nut
• Caution: only after mechanical installation can electrical
connection be made.
• Important note to installation:
If luminaire type SLM is to be fitted to an existing screwed sight
port, a matching slotted cover nut should be ordered with the
luminaire or the existing cover nut modified to suit.
• Electrical connection:
- select correct cable to suit operating conditions
- cable diameter must suit cable entry gland
- loosen lamp box cover screws and remove cover
- pass cable through gland and wire to terminals
- tighten gland
- fit undamaged gasket to lid and tighten screws
Complete Lumiglas Luminaire of the SLM Series
Lumiglas Luminaire type SLM
lumiglas®
F.H.Papenmeier GmbH & Co. KG · division Lumiglas
Talweg 2 · 58239 Schwerte · GERMANY
phone: +49-2304/2050 · fax: +49-2304/205206
e-mail: info.lumi@papenmeier.de
www.lumiglas.de