Testboy Profi LED Plus0 pages
Due to its wide performance spectrum, the Testboy Profi LED Plus is one of the most sought after
products in ourassortment.
The Profi LED Plus combined the following 7 features in one unit:
| Display DC and AC voltage from 6 to 1000V
| Single – pole phase testing
| Two – pole phase sequence indication
| Continuity testing up to 500Ω (acoustically / optically)
| RCD – testing lever two button
| LED torch lamp
| Removable 4 mm test tips adaptor
The professional appearance is underlined by the mix of materials used in the plastic housing and the
rubber handle. The Display area is protected by a break proof plastic disk. Even when in daily use, the
robust construction as well as the dust and waterproof housing guarantee a long service life. The test
tips are protected by a removable cap that in turn is secured to the device.
Also the usage of LED`s for all optical indications guarantee you maximum reliability. When the probe
tips are connected to an AC voltage within the nominal voltage range, the reading is displayed in volts
and the “+~-” LED indicator lights up. From a voltage more than 35V (life risk) a buzzer sounds up.
The switchable load per button impeded the unmeant triggering of the RCD – switch, so that the
protective earthing conductor can be measure as well. With throughput testing up to 500kΩ, it sounds
an acoustical signal.
Your advantages:
| 5 years manufacturer’s warranty
| TÜV/GS tested and approved
| IEC/EN 61243-3 (DIN VDE 0628-401)
Technical Details
Testboy Profi LED Plus
Display
optical 12 LEDs
Operating panel
finger tip / RCD button
Measurement range automatic range
Voltage range
6 - 1000V AC/DC, 0 - 400Hz
Continuity test
0 - 500k with acoustical signal
Phase indication
> 100V AC
Switchable load
Is ~ 30mA ED(DT) = 30 sec.
Power supply
2x 1,5V
Overload category
CAT IV 1000V